Technical Manual
GENERAL DESCRIPTION
The TiTAN-QD™ is a light-weight, ultra-high-efciency, fast-
attach, multi-caliber silencer and ash suppressor designed for
use on precision ries chambered for the .338 Lapua Magnum, .300
Winchester Magnum, and 7.62mm Nato cartridges. Through the use
of a proprietary muzzle brake, users of the TiTAN-QD™ are able to
attach or detach the silencer in less than ve seconds. Constructed
of welded Titanium alloy, the TiTAN-QD™ will provide a lifetime of
service under the most demanding conditions. Patented HYPOSONE®
technology gives the TiTAN-QD™ an excellent size to performance
ratio and delivers unparalleled sound, ash, and recoil reduction
while maintaining pinpoint accuracy.
TECHNICAL SPECIFICATIONS
Caliber .338 LM, .300WM, 7.62mm Nato
Silencer Construction Materials Titanium Alloy
Compensator Construction Materials Stainless Steel
Weight 20 ounces
Length (O.A.) 9.5 inches
Diameter 1.8 inches
Silencer Finish Flat Black, Dark Earth, or Desert Tan
Compensator Finish SCARmor™
WARNING
Failure to follow the instruction set forth in this manual can
create a potentially dangerous situation for the operator and
damage to the silencer and host firearm.
REMOVING THE SILENCER
1. Set the host rie on “SAFE”. Remove the magazine, open the
bolt, and verify the chamber is empty.
2. Depress the thumb pad on the ratchet latch (indicated by the
arrow), and unscrew the silencer from the muzzle brake in the
indicated direction (See Figure 2).
NOTES ON MUZZLE FLASH REDUCTION
Operational circumstances may require the complete elimination of
muzzle ash. In this instance, the use of water to create an articial
environment is warranted.
To wet the interior of the silencer:
1. Detach it from the host weapon and submerge it in water.
2. Rotate the silencer around its vertical axis to drain excess
water from the interior of the silencer.
Note: If submersion in
water is not possible, 5cc’s (approximately 1 cap full from a water
bottle) may be poured into the rear of the detached silencer.
3. Shake the silencer several times to help distribute water within
the environment cells of the silencer.
If the host weapon is not discharged after water is added, the water
will remain inside the silencer for up to 36 hours, depending on the
ambient temperature.
TiTAN-QD
™
SILENCER TECHNICAL MANUAL
AAC BLACKOUT
™
SERIES
ADVANCED ARMAMENT CORP.
770-925-9988 (Voice) 770-925-9989 (Fax)
www.advanced-armament.com
All content © 2011 ADVANCED ARMAMENT CORP.
Specifications subject to change. REV 1 JAN2011
FIGURE 2