Operation and Maintenance Manual

REASSEMBLING YOUR Ti-RANT 45-M
1. Assemble the baffle stack for
the main tube body by plac-
ing one of the two front baf-
fles cone-side down on a flat,
level surface. The front baf-
fles can be identified by their
light grey color and absence
of notches on the cone. See
Figure 25.
2. On top of the front baffle,
place one of the black an-
odized aluminum baffles so
that the output port at the
junction of the disk and cone
is 180° opposite the output
port of the grey front baffle.
The two baffles will rotation-
ally lock together using the
tabs on the disk and notches
on the cone. See Figure 26.
2. Place three more black an-
odized aluminum baffles
atop the stack, with the out-
put ports aligned with the
output port in the first black
aluminum baffle. Ensure all
tabs and notches engage.
See Figure 27.
3. Place the ported blast baffle
atop the stack, so that the
output port of the blast baffle
aligns with the output ports
on the preceding four black
aluminum baffles. See Fig-
ure 28.
4. Slide the tube body over the assembled stack. See Figure 29.
5. Thread the
empty front
module fully
onto the tube
body, capturing
the baffles in the
tube body. See
Figure 30.
6. Looking in the
front of the tube,
take note of the
location of the
output port,
which is shown
in red for clarity
in Figure 31.
7. The first baffle to be placed in the
front module is the transition baf-
fle. It is distinguished from the
other grey anodized baffles by
it’s angled rear face and lack of
tabs. See Figure 32. Insert the
transition baffle into the front
module so that the output scoop
is aligned with the output scoop
in the front baffle in the main tube
body. See Figure 33.
8. The next baffle to go into the
front module is the grey anodized
baffle with both rear tabs and
notches on the cone. Place it
atop the transition baffle and tab
the two together so that the out-
put ports are aligned. See Figure
34.
9. The final baffle to install in the
front module is the second front
baffle. Install it and tab it to the
SILENCER MODEL Ti-RANT 9-M P.13 SILENCER MODEL Ti-RANT 9-M P.14
Figure 25
Figure 26
Figure 27 Figure 28
Figure 30
Figure 31
Figure 32
Angled
Rear Face
Transition
Baffle
Figure 33
Figure 34
Figure 29