Operation and Maintenance Manual

WARNING! User must ensure the
silencer stays securely threaded
to the host-firearm muzzle
threads during use. Failure to en-
sure the silencer stays securely
threaded to the host-firearm muz-
zled threads may lead to property
damage, personal injury and/or
death.
REMOVING A Ti-RAID 30 FROM A HOST FIREARM
-DIRECT-THREAD CONFIGURATION-
1. Always keep the host firearm pointed in a safe direction.
2. Render the firearm safe by removing the magazine, completely unload-
ing the firearm and engaging the safety mechanism to the "SAFE" po-
sition. See the firearm's owner's manual for detailed instructions.
3. Verify the silencer is at ambient temperature. If the silencer is hot, allow
it to cool.
CAUTION! Never handle a hot si-
lencer without heat-resistant
gloves, as this may lead to skin
burns and/or personal injury.
4. While firmly grasping the direct-
thread mount, unscrew the si-
lencer from the muzzle threads in
the direction indicated in Figure
20.
DISASSEMBLING THE Ti-RAID 30
WARNING! Only perform disassembly procedures on silencers that
are not mounted to a firearm. Attempting disassembly on a mounted
silencer could lead to property damage, personal injury and/or death.
1. If the Ti-RAID 30 is mounted to a host firearm, dismount it following the
procedure outlined in “Removing the Ti-RAID 30 from a host firearm” in
this manual.
2. Begin disassembly by unscrew-
ing the mount from the tube body.
See Figure 21. NOTE: It may be
necessary to secure either the
90T Ratchet Taper Mount or the
tube body using a vice or other
work holding device in order to
unscrew the tube body and the
mount.
3. Remove and set aside the
mount-tensioning wave spring
from rear of the expansion cham-
ber. See Figure 22.
4. Extract the expansion chamber
from the tube body. See Figure
23.
5. Tilt the tube body as shown in
Figure 24. The seven baffles and
front chamber should fall free
from the tube body. If the baffles
and front chamber will not easily
fall free, push on the exposed
face of the front chamber to free
the baffles and front chamber
from the tube body. See Figure
25
6. Separate the baffles and front
chamber. See Figure 26. Disas-
sembly is complete.
SILENCER MODEL Ti-RAID 30 P.11 SILENCER MODEL Ti-RAID 30 P.12
Figure 19
Figure 20
Figure 21
Figure 22
Figure 23
Figure 24
Figure 25
Wave Spring
Expansion
Chamber
Baffle
Stack
Front
Chamber