Operation and Maintenance Manual

REMOVING A Ti-RAID 30 FROM A HOST FIREARM
-51 TOOTH RATCHET MOUNT FAST-ATTACH CONFIGURATION-
1. Keep the host firearm pointed in a safe direction.
2. Render the firearm safe by removing the magazine, completely unload-
ing the firearm and engaging the safety mechanism to the "SAFE" po-
sition. See the firearm's owner's manual for detailed instructions.
3. Verify the silencer is at ambient temperature. If the silencer is hot, allow
it to cool.
CAUTION! Never handle a hot si-
lencer without heat-resistant
gloves, as this may lead to skin
burns and/or personal injury.
4. While firmly grasping the mount,
depress and hold the textured
thumb-pad on the ratchet latch
and unscrew the silencer from
the muzzle brake in the direction
indicated in Figure 14.
INSTALLING A Ti-RAID 30 SILENCER ONTO A HOST FIREARM
-DIRECT-THREAD CONFIGURATION-
WARNING! Never attempt to attach a Ti-RAID 30 to muzzle threads
that are dirty or damaged, as this may lead to property damage, per-
sonal injury and/or death.
WARNING! Never attempt to attach a Ti-RAID 30 with dirty or dam-
aged threads to a threaded muzzle, as this may lead to property dam-
age, personal injury and/or death.
WARNING! Never use a silencer with an obstructed bore, as this may
lead to property damage, personal injury and/or death.
1. Always keep the firearm pointed in a safe direction.
2. Render the firearm safe by removing the magazine, completely unload-
ing the firearm and engaging the safety mechanism to the "SAFE" po-
sition. See the firearm's owner's manual for detailed instructions.
3. Remove the existing flash hider and any washers or shims from the
host firearm muzzle.
4. Clean the threads and shoulder
on the host-firearm muzzle and
verify they are undamaged. See
Figure 15.
5. Verify the thread specification on
the Direct-Thread mount
matches the threads on the host
firearm muzzle. The mount
thread specification is marked
on the mount. See Figure 16.
6. Inspect the threads in the rear of
the Direct-Thread Mount to ver-
ify they are clean and undam-
aged. See Figure 17.
7. Look through the silencer from
the rear to ensure the bullet path
through the silencer is unob-
structed.
8. Examine the silencer for any
signs of damage.
9. Hold the silencer by the direct-
thread mount and carefully
screw it onto the muzzle threads
in the direction indicated in Fig-
ure 18. Thread the silencer on
completely so that the rear of
the direct-thread mount sits
flush and square against the
shoulder behind the threads.
See Figure 19.
SILENCER MODEL Ti-RAID 30 P.9 SILENCER MODEL Ti-RAID 30 P.10
Figure 14
Textured
Thumb
Pad
Figure 15
Muzzle
Threads
Shoulder
Figure 16
Thread
Identification
Figure 18
Grasp Here
Figure 17
Threads