Operation and Maintenance Manual

INSTALLING A Ti-RAID 30 SILENCER ONTO A HOST FIREARM
-51 TOOTH RATCHET MOUNT FAST-ATTACH CONFIGURATION-
WARNING! Never attempt to attach a Ti-RAID 30 to a BLACKOUT Si-
lencer-Mounting muzzle device with threads that are dirty or dam-
aged, as this may lead to property damage, personal injury and/or
death.
WARNING! Never attempt to attach a Ti-RAID 30 with dirty or dam-
aged threads to a BLACKOUT Silencer-Mounting muzzle device, as
this may lead to property damage, personal injury and/or death.
WARNING! Never use a silencer with an obstructed bore, as this may
lead to property damage, personal injury and/or death.
1. Always keep the firearm pointed in a safe direction.
2. Render the firearm safe by removing the magazine, completely unload-
ing the firearm and engaging the safety mechanism to the "SAFE" po-
sition. See the firearm's owner's manual for detailed instructions.
3. Inspect the ACME thread on the
exterior of the 51T BLACKOUT
Silencer-Mounting muzzle de-
vice, the toothed gear behind
the threads, and the silencer
alignment surfaces to verify they
are clean and undamaged. See
Figure 8.
4. Verify the fast-attach mount is
compatible with the 51T BLACK-
OUT Silencer-Mounting muzzle
device mounted to the host
firearm. The fast-attach mount
designation is marked on the
mount. See Figure 9.
4. Inspect the threads in the rear of
the 51T Ratchet Mount to verify
they are clean and undamaged.
See Figure 10.
5. Look through the silencer from
the rear to ensure the bullet path
through the silencer is unob-
structed.
6. Examine the silencer for any
signs of damage.
7. Grasp the silencer by the in-
stalled mount and slide the Ti-
RAID 30 over the 51T
BLACKOUT Silencer-Mounting
muzzle device. See Figure 11.
8. Hold the Ti-RAID 30 by the
mount and while keeping the
textured thumb pad of the latch
depressed, carefully screw the
silencer onto the 51T BLACK-
OUT Silencer-Mounting muzzle
device threads in the direction
indicated in Figure 12.
9. Tighten the silencer fully onto
the 51T BLACKOUT Silencer-
Mounting muzzle device hand-
tight until the tapered alignment
surface adjacent to the toothed
gear on the BLACKOUT Si-
lencer-Mounting muzzle device
fully engages the mating ta-
pered alignment surface in the
rear of the Ti-RAID 30 silencer.
See Figure 13.
WARNING! User must ensure the
silencer stays securely threaded to the BLACKOUT Silencer-Mount-
ing muzzle device during use. Failure to ensure the silencer stays se-
curely threaded to the BLACKOUT Silencer-Mounting muzzle device
may lead to property damage, personal injury and/or death.
SILENCER MODEL Ti-RAID 30 P.7 SILENCER MODEL Ti-RAID 30 P.8
Figure 9
Mount
Identification
Figure 11
Figure 12
Figure 10
Mount
Threads
Figure 8
Silencer
Alignment
Surfaces.
ACME
Thread
Toothed
Gear
Figure 13
Tapered Surfaces
Silencer
Shown Sectioned