Operation and Maintenance Manual

5. Inspect the threads in the rear of
the 90T Ratchet Taper Mount to
verify they are clean and un-
damaged. See Figure 3.
6. Look through the silencer from
the rear to ensure the bullet path
through the silencer is unob-
structed.
7. Examine the silencer for any
signs of damage.
8. Grasp the silencer by the in-
stalled mount and slide the Ti-
RAID 30 over the 90T Ratchet
Taper BLACKOUT Silencer-
Mounting muzzle device. See
Figure 4.
9. Hold the Ti-RAID 30 by the
mount and while keeping the
textured thumb pad of the latch
depressed, carefully screw the
silencer onto the 90T Ratchet
Taper BLACKOUT Silencer-
Mounting muzzle device threads
in the direction indicated in Fig-
ure 5.
10. Tighten the silencer fully onto
the 90T Ratchet Taper BLACK-
OUT Silencer-Mounting muzzle
device hand-tight just until the
tapered alignment surface adja-
cent to the toothed gear on the
90T Ratchet Taper BLACKOUT
Silencer-Mounting muzzle device engages the mating tapered align-
ment surface in the rear of the Ti-RAID 30 silencer. When the silencer
is fully engaged with the 90T Ratchet Taper BLACKOUT Silencer-
Mounting muzzle device, release tension on the textured thumb pad.
There should be no perceptible movement between the 90T Ratchet
Taper BLACKOUT Silencer-
Mounting muzzle device/host
rifle and the Ti-RAID 30 silencer.
See Figure 6.
WARNING! User must ensure the
silencer stays securely threaded
to the 90T Ratchet Taper BLACK-
OUT Silencer-Mounting muzzle
device during use. Failure to en-
sure the silencer stays securely
threaded to the BLACKOUT Silencer-Mounting muzzle device may
lead to property damage, personal injury and/or death.
NOTE. Do not over-tighten the silencer onto the 90T Ratchet Taper
BLACKOUT Silencer-Mounting muzzle device/host firearm, as it may
be difficult to remove.
REMOVING A Ti-RAID 30 FROM A HOST FIREARM
-90 TOOTH RATCHET TAPER FAST-ATTACH CONFIGURATION-
1. Keep the host firearm pointed in a safe direction.
2. Render the firearm safe by removing the magazine, completely unload-
ing the firearm and engaging the safety mechanism to the "SAFE" po-
sition. See the firearm's owner's manual for detailed instructions.
3. Verify the silencer is at ambient temperature. If the silencer is hot, allow
it to cool.
CAUTION! Never handle a hot si-
lencer without heat-resistant
gloves, as this may lead to skin
burns and/or personal injury.
4. While firmly grasping the mount,
depress and hold the textured
thumb-pad on the ratchet latch
and unscrew the silencer from
the muzzle brake in the direction
indicated in Figure 7.
SILENCER MODEL Ti-RAID 30 P.5 SILENCER MODEL Ti-RAID 30 P.6
Figure 2
Mount
Identification
Figure 4
Figure 5
Figure 6
Tapered Surfaces
Silencer
Shown Sectioned
Figure 7
Textured
Thumb
Pad
Figure 3
Mount
Threads