Operation and Maintenance Manual

SILENCER MODEL Ti-RAID 30 P.15 SILENCER MODEL Ti-RAID 30 P.16
Front
Chamber
RH Vents
LH Vents
No Vents
Expansion
Chamber
Figure 34
Figure 35
baffle. The completed internal
component stack is shown in
Figure 35.
5. Slide the tube body over the as-
sembled baffle stack so that the
tabs on the rear of the tube body
engage the notches on the rear
of the expansion chamber. See
Figure 36.
NOTE: The tab and notch rela-
tionship of the tube body and ex-
pansion chamber enables users
to rotationally adjust the baffle
stack in 36 degree increments to
minimize point of impact shift.
The optimum baffle alignment is
one that orients the shear cuts of
the baffles as close to vertical , ei-
ther up or down, when mounted
to the host firearm. See Figures
37 and 38.
6. Turn the assembled tube body
upright and place the wave
spring on the circular boss on
the rear of the expansion cham-
ber. See Figure 39.
8. Hold the reassembled tube body
upright and thread the mount
onto the tube. Resistance will be
felt as the wave spring is com-
pressed between the mount and
the expansion chamber. Thread
the mount to the tube, by hand,
until the mount will tighten no
further. See Figure 40.
Figure 38
Figure 37
Figure 39
Figure 40
Shear
Cut
Shear
Cut
Wave
Spring
Expansion
Chamber
Boss
Figure
36
Tube
Body
Tabs
Notches
LH Vents
No Vents
RH Vents
LH Vents
LH Vents
RH Vents
LH Vents
RH Vents
LH Vents