Operation and Maintenance Manual

standard baffle so that the notch
in the front chamber engages the
tab on the front of the front-most
baffle. See Figure 26.
4. Turn the engaged front
chamber/first baffle until the com-
bination rotationally tabs to and
locks into the second standard
baffle. See Figure 27.
5. Repeat this process until the front
chamber and all five standard baf-
fles tab onto the caged blast baf-
fle, which will engage the front of
the piston housing. See Figure 28.
Once the aligned stack en-
gages the front of the piston
housing, the stack will no
longer turn.
6. Remove the front chamber
and insert the short, front
baffle into the tube. Use the
front chamber to engage the
notch on the front baffle with
the tab on the aligned stack
of adjacent standard baffles.
See Figure 29.
7. Install the front nut. See Fig-
ure 30.
8. Hold the silencer up to the
light and look through the
projectile passage. The pas-
sage should be circular (See
Figure 31). If the passage is
not circular, or appears
blocked, remove the baffle
stack and repeat steps 1-8.
WARNING! - Do not install
and use an ILLUSION 9 with
an improperly assembled baf-
fle core. Using an ILLUSION 9
with an improperly assem-
bled baffle core may lead to
property damage, personal
injury and/or death.
REASSEMBLING YOUR A.S.A.P. SYSTEM
1. Place the driving spring around the piston shaft. See Figure 32.
2. Insert the piston and driving spring into the piston housing assembly.
See Figure 33.
SILENCER MODEL ILLUSION 9 P.13 SILENCER MODEL ILLUSION 9 P.14
Figure 25
Figure 29
Figure 26
Figure 27
Figure 28
Figure 30
Figure 31