Operation and Maintenance Manual

7. Using a paper towel or shop cloth, clean the threads inside the lock
ring. See Figure 16.
8. Lubricate the threads on the
interior of the front module
and the rear main tube with
a light coat of white lithium
grease or anti seize com-
pound. See Figure 28.
9. Lubricate the adapter
mount bore and O-ring with
a thin coat of white lithium
grease or anti-seize com-
pound. See Figure 16.
10. Lubricate the threads inside the lock ring with a thin coat of white
lithium grease or anti-seize compound. See Figure 18.
WARNING! All traces of solvent must be allowed to evaporate com-
pletely prior to reassembly. Failure to remove all solvent from the si-
lencer prior to use presents a risk of fire or explosion and may lead
to property damage, personal injury and/or death.
REASSEMBLING YOUR HALCYON
1. There are three different types of baffles in the HALCYON: the ported
blast baffle, five standard baffles with integral spacers, and a transition
baffle. All of the baffles incorporate a tab and notch design that forces
the rotational orientation of each baffle to be 180° from each adjacent
baffle. See Figure 29.
2. Build the rear main tube baffle stack by placing one of the standard
baffles cone-side down on a level, flat work surface. See Figure 30.
3. Continue building the stack by placing the cone of another standard
baffle inside the spacer on the backside of the first baffle. Rotate the
second baffle until the notch on the cone of the second baffle engages
the tab on the inside of the spacer of the first baffle. When properly en-
gaged, the baffles will nest together with no gap between them. See
Figure 31.
4. Place another standard baffle on the stack, rotating it until its notch and
the second baffle engage. See Figure 32.
5. The last baffle to go on the rear main tube baffle stack is the ported
blast baffle. It can be identified by it’s lack of spacer, and single port
hole in the rear face. Place the ported blast baffle in the spacer of the
top standard baffle, and rotate it until the notch on the front of the cone
of the ported blast baffle engages the tab inside the spacer of the third
standard baffle. See Figure 33.
SILENCER MODEL HALCYON P.13
SILENCER MODEL HALCYON P.14
Figure 29
Ported
Blast
Baffle
Notch
Tab
Standard Baffles
Transition
Baffle
Figure 30 Figure 31
Figure 32 Figure 33
Ported
Blast
Baffle
Standard
Baffles
Figure 28
Lubricate
Threads
Lubricate
Threads
No
Gap