Operation and Maintenance Manual

6. Slide the main tube body
over the baffle stack. See
Figure 34.
7. Turn the rear main tube and
it’s baffles upright. Thread
the front module into the
rear main tube, capturing
the rear main tube baffles
inside the tube. See Figure
35.
8. The baffle stack for the front
module is comprised of two
standard baffles, and the
transition baffle. See Figure
36.
9. Slide the assembly of the
rear main tube and front
module over the assembled
front module baffle stack.
See Figure 37.
10. Turn the assembled rear
main tube and front module
upright. Rotate the baffles in
the front module until the
tab on the transition baffle
engages the notch on the
cone of the front-most stan-
dard baffle in the rear main
tube. See Figure 8.
11. Thread the front end cap
fully into the front module
and tighten securely. See
Figure 9.
WARNING! Do not attempt to use a HALCYON silencer with an im-
properly assembled baffle stack. Using a HALCYON silencer with an
improperly assembled baffle stack may lead to property damage, per-
sonal injury and/or death.
Figure 38 depicts a cross
sectional view of a properly
assembled HALCYON baffle
stack.
12. Insert the thread adapter
into the bore. Rotate the
adapter so that the two tabs
on the rear of the main tube
body engage the mating
notches in the flange on the
thread adapter. See Figure
17.
13. Install the wave spring on
the thread adapter shaft.
See Figure 19.
14. Fully thread the lock ring onto the threads on the rear of the main tube
body. See Figure 20.
SILENCER MODEL HALCYON P.15 SILENCER MODEL HALCYON P.16
Figure 36
Figure 38
Figure 35
Main
Tube
Body
Front
Module
Transition
Baffle
Standard
Baffles
+
+
=
Figure 37
Figure 34
Main
Tube
Body