Assembly Instructions

This device complies with part 15 of the FCC Rules. Operation is subject to the condition that (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
Specific absorption rate (SAR):
This Tablet meets the government's requirements for exposure to radio waves. The guidelines are based
on standards developed by independent scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a margin of safety designed to ensure the safety of
all people regardless of their age or health.The FCC Statement of Exposure to RF and the SAR limit for the
United States (FCC) is 1.6 W/kg average for each gram of tissue. This device was tested for typical
operations of use on the body, with the back of the Tablet from the body. To maintain compliance with
FCC RF exposure requirements, use accessories that maintain between the user's body and the back of
the phone. The use of belt clips, covers and similar accessories must not contain metallic components in
their assembly. The use of accessories that do not meet these requirements may not meet
FCC RF exposure requirements and should be avoided.Functioning in the body This device was tested for
typical operations of use in the body. To comply with RF exposure requirements, a minimum separation
must be maintained between the user's body , including the antenna. Third-party accessories such as belt
clips. covers and similar accessories used with this device should not contain metallic components,
accessories that do not meet these RF exposure requirements and should be avoided from use on the
body. Use only the supplied antenna or an approved antenna.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.