Installation and Operation Manual for Electric and Gas Hot Food Units

CAUTION: When loading the pans into the wells, do not drop the pans

as this may cause the pilot ﬂame or the main burner ﬂame to be extinguished

from the concussion. Always check the pilot and burner ﬂames after

loading pans into the wells.

FOLLOW THESE INSTRUCTIONS FOR GAS MODELS ONLY.

LIGHTING INSTRUCTIONS:

For The HF & WB Series

1. Turn all control and the main gas valves to the off position. Wait at least 5 minutes

before trying to light the pilots. This will allow any gas that has accumulated in the

burner compartment to escape.

2. After waiting 5 minutes, open the main gas valve and place a lighted match at each pilot

and adjust the pilot to a height of at least 5/8 inches. This can be performed by taking

a screwdriver and placing it in the pilot adjustment screw slot and turning it. Turn the

screw counter clockwise to increase the pilot ﬂame, or clockwise to make decrease it.

(See Figure 4)

3. If the pilot extinguishes, repeat the lighting instructions beginning with STEP 1.

4. Turn the main burner valve in a counter clockwise direction to the desired setting. If the

main burners do not light within 4 seconds, then repeat the light instructions

beginning with STEP 1.

For The SPWB Series

1. Turn all manual valves to the off position. Wait at least 5 minutes before trying to

light the pilots. This will allow any gas that has accumulated in the burner compartment

to escape.

2. Depress the reset button while holding a lighted match to the pilot. Keep the button

depressed for at least 60 seconds so that the pilot will remain lit.

3. Release the reset button, if the pilot does not stay lit, then repeat the lighting instructions

beginning with STEP 1 and allow a longer period of time before releasing the button.

4. Adjust the pilot ﬂame to a minimum height of at least 5/8 inches. This can be performed

by ﬁrst removing the pilot adjustment screw cap located on the valve. Next turn the pilot

adjustment screw to the approximate ﬂame height. Finally, replace the pilot adjustment

screw cap.

5. If the pilot remains lit, then turn the main burner valve in a counter clockwise direction to

the desired setting. If the main burners do not light within 4 seconds, then repeat the

light instructions beginning with STEP 1.

Figure 4