User Manual

C.
LCD
TRANSCEIVER
REMOTE
CONTROL:
1. Press the buttons the number of times corresponding to the Level you wish to select; the LCD will display LEVEL
number ( )
2. Press the button while LEVEL number text is still on to perform the command.
Button
Direct Access x 1 Level 1 x 2 Level 2 x 3 Level 3
Arm & Lock
Aux 1 Aux 2
1 sec.
Silent Arming
Vehicle’s Status Check /
Alarm Report
Button Beeper Button Lock
Disarm & Unlock or Silent
Disarming
Remote Valet Tone / Vibrating Mode Car 1 / Car 2 operation
Remote Start or Running
Time Extender
Timer Start Daily Timer Start Power Save Mode
Vehicle’s Status Check / Alarm Report: Press button
1
time first then press and hold buttons for 1 second. The
LCD remote transceiver will display current status of the vehicle. (Include trigger state of vehicle).
Button Beeper: Press button
2
times first then press and hold buttons for 1 second to enter Button Beeper Mode.
Under this mode press button to turn on the button beep or turn off the button beep .
Button Lock Mode: Press button 3 times first then press and hold buttons for 1 second to enter Button Lock Mode.
Under this mode press button to select Button Lock On or Off. The remote control will beep/vibrate 2 times and
icon will display when a button is pressed indicating it is locked.
Tone / Vibrating Mode: Press button 2 times first then press button to enter Tone / Vibrating Mode. Under this
mode press button to select Tone Mode ( icon will display) or Vibrating Mode ( icon will display) or both ( and
icon will display).
Second Vehicle Security Operation: Press button 3 times first then press button to enter Second Vehicle Security
Mode. Under this mode press button to select CAR 2 operation ( icon and will display) or CAR 1 operation,
the icon will disappear and display on the LCD screen)
Power Saver Mode: Press button 3 times first then press button to enter Power Saver Mode, Under this mode
press button to enable power saver mode and icon will display or disable power save mode and icon will
disappear While in Power Save Mode the LCD transmitter will not look for any incoming signals from the main unit until a
button is pressed.
EXIT: Wait 10 seconds, or press the other buttons to leave the setting except the button
D. CHIRP INDICATORS
PARKING LIGHT
Chirp Function Parking light Function
1 Chirp Arm 1 Flash Arm
2 Chirps Disarm 2 Flashes Disarm
3 Chirps Defective Reminder 3 Flashes Disarm / Triggered Warning
4 Chirps Disarm / Triggered Warning 12 Flashes Car Finder
6 Chirps Car Finder Constant On Under Remote Start
Click to buy NOW!
P
D
F
-
X
C
h
a
n
g
e
V
i
e
w
e
r
w
w
w
.
d
o
c
u
-
t
r
a
c
k
.
c
o
m
Click to buy NOW!
P
D
F
-
X
C
h
a
n
g
e
V
i
e
w
e
r
w
w
w
.
d
o
c
u
-
t
r
a
c
k
.
c
o
m
FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.