User's Manual

2016/7/19
4250 Rev.A
6
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the
ignition switch- All will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking.
The siren and parking lights will turn on to alert of an intrusion for 30 seconds.
Then the siren will stop and automatically reset and re-arm. If any the sensors or
detectors are still active, the alarm system will sound a maximum of three-30
second cycles.
Trunk/Hood
Trigger
Doors
Trigger
Shock
Sensor
Trigger
Ignition
Trigger
Warn-away
Trigger
NOISE ABATEMENT CIRCUIT:
Your system has “Noise Abatement Circuit”. It prevents annoying repetitive trigger
sequences due to faulty door pin switches or environmental condition such as
thunder, jackhammers, airport noise, etc. Here’s how “Noise Abatement Circuit”
works: The alarm triggers five times. Each time, the same sensor or switch is
triggering the alarm. “Noise Abatement Circuit” will interpret this pattern of triggers
as false alarm. After the fifth trigger, “Noise Abatement Circuit” ignores, or
bypasses, that sensor or switch until the other sensor or switch is trigger.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm is
triggered by an open door for three full cycles, the doors will be bypassed until the
trigger ceases.