User's Manual
2016/7/19
4250 Rev.A
5
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will
sound.)
2. Within 10 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now start and
operate the vehicle normally.
VALET MODE:
The valet switch allows you to temporarily bypass all alarm function, eliminating the
need to hand your transmitter to parking attendants or garage mechanics. When
the system is in valet mode, all alarm functions are bypassed, however, the remote
panic feature and remote door locks will remain operational.
Enter Valet Mode:
1. From the disarmed condition,
turn the ignition to “ON”
position.
2. Push and hold valet switch for
2 seconds until the LED turns
on. The LED wills remain on
as long as the system is in
'valet mode'.
Remote Door Lock
Remote Door Unlock
Exit Valet Mode: Return to normal operation, turn ignition 'ON'.
1. Push and hold valet switch for 2 seconds; the LED will turn off indicating the
system is exiting the valet mode.
POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to remember
its alarm state if the power is lost and then reconnected.
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm
in case of emergency.
1. Press and hold the
button on the transmitter for 3 seconds. The alarm will
immediately sound.
2. During panic mode, the normal function of this transmitter button will be
suspended. The
and
buttons can be used to lock and unlock the doors (if the
option is installed), however once the
button is pressed, the vehicle’s starter
disable device, (where installed) will be enable allowing the vehicle to start.
3. To stop the alarm, press and hold the
or
or
button on the transmitter for
3 seconds. Also if the
button is pressed and released, the panic mode will be
turned off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30
seconds.