Manualshelf

User's Manual

ManualsBrandsAdvance Security ManualsElectronicsRemote Control
891011121314151617
11CA4B - CA2LED Owners rev A.
Remote Start Override Mode (Valet Mode) - AS9234E
The intent of the remote start override / manual shut down circuit is to allow the
vehicle operator to prevent operation of the Remote Start Unit regardless of the RF
transmitter operation.
Enter Remote Start Override:
1. With the system disarmed/unlocked, and the ignition switch off Press and
Hold the PBLED push button switch (dash mounted).
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED begins to ash two short ashes followed by one long ashes
and continues this pattern until returned to normal mode of operation.
The action above puts the unit into the Remote Start Override mode or vehicle service
mode and will not start from the RF transmitter or any other input.
Exit Remote Start Override:
1. With the system disarmed, Press and Hold the PBLED push button
switch (dash mounted) on.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED turns off indicating that the R/S unit is fully functional one again.
Valet Mode: (Alarm Systems Only) Dash-Mounted Push-Button LED Valet/
Override Switch:
The Push-Button LED switch (PBLED Switch) located on vehicle’s dash allows you to
temporarily bypass all alarm functions, eliminating the need to hand your transmitter
to parking attendants or garage mechanics. When the system is in valet mode,
all alarm functions are bypassed, however the remote panic feature and remote
door locks will remain operational. To use the valet mode, the system must rst be
disarmed either by using your keychain transmitter, or by activating your personalized
manual override code.
1. Enter the vehicle, and turn the ignition key to the on position.
2. Press and hold the Push-Button switch until the LED turns on solid. The
system will remain in the valet mode.
3. To return to normal operation, press and release the Push-Button switch
any time the ignition is on.
NOTE: Always remember to return the vehicle to the valet off position. This will
ensure that the vehicle remains protected at all times.