User's Manual

12
1. Turn Ignition On => Off
2. After above (1) within 15 seconds, (ref. page-6 2-way HHU quick feature programming => Enable Time start.) p
ress
and hold
F button of LCD remote until 3 beeps sound , release and re-press F button until LCD show “
“ icon flash on LCD remote (see Table 3), then press
button to activate Time Start. icon illuminate
on LCD display,
parking light flash / siren chirp 3 or 2 times confirm. The vehicle is now programmed to start every 3
or 2 hours
Exit : Turn Ignition On (LED and parking light flash 4 times, and siren chirp 4 times confirm exit Time Start).
(p.s. press lock or unlock button to turn off
icon on 2-way remote)
Daily Start :
Enter :
1. Turn Ignition On => Off
2. After above (1), within 15 sec. ref. page-6 2-way HHU quick feature programming => Enable Daily Start (
Press &
hold
F button of LCD remote until 3 beeps heard, release and re-press F button to move blinking
cursor to “
“ (see Table 3), then press button to activate Daily Start. icon illuminate on LCD
display,
parking light flash / siren chirp 6 times confirm Daily Start programmed.
Exit : Turn Ignition On (LED and parking light flash 4 times, and siren chirp 4 times confirm exit Daily Start).
(p.s. press lock or unlock button to turn off
icon on 2-way remote)
F. TEMPERATURE CHECK
The unit can monitor the present indoor temperature of the passenger compartment before cooling or heating your
vehicle. P
ress and hold F button of LCD remote until 2 beeps sound , release and re-press F button for
4 more times, the LCD remote will show “TEMP CHECK“ icon (see Table 2- 5), then press
button; the
in-door temperature will be shown on the LCD screen. This reading may be higher than actual ambient temperature
due to the greenhouse and is relative only the inside vehicle temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press
button once on the remote transmitter under remote start mode.
2. Move the optional remote start enable toggle switch to OFF position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking light to indicate engine stopped.
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not start or will shut
down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. The parking (hand) brake is released (For Standard Transmission Gear Vehicle or Turbo Timer Mode)
4. Engine is over-reviewed. {“Tachometer checking type” only}
5. The pre-programmed run time
(5 /10 / 20 / 30 minutes) has elapsed.
6. Press
button twice on the remote transmitter under remote start mode.
7. The system trigger.
8. The vehicle refused to start running after {3} unsuccessful attempts.
I. DISABLING THE REMOTE START SYSTEM: (If installed)
This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from being remote
started accidentally. This feature is useful if the vehicle is being serviced or stored in an enclosed area. To disable the
remote start, move the optional remote start enable toggle switch to the OFF position.