User's Manual

2013/05/29
RS-777 OP REV 1D
12
1.Before turning off the engine, press the button once on the transmitter and the LED indicator will flash 3 times
to confirm.
2.Turn the ignition key to OFF position. (The engine will stay running.)
3.The engine will run until the pre-programmed time elapsed or shutdown input is received.
D. TURBO CHARGE MODE:
Turbo charge mode keeps the engine running after arriving at you destination for a programmable period of 1, 3 or 5
minutes, This allows the vehicle’s engine time to conveniently cool down the turbo after you have left the vehicle. To
activate:
1. While the engine is running, pull up the hand brake and place the transmission gear in the park position.
2. Before turning off the engine, press and release and buttons at the same time.
-- The LED will flash indicating the remote start has entered the turbo charge mode appear on LCD
remote.
3. Take the “Ignition Key” from the key cylinder.
-- Engine keeps running. --
4. Exit and secure the vehicle.
-- Engine continues running until the pre-programmed time elapsed. --
Or
1. While the engine is running, pull up the hand brake and place the transmission gear in the park position.
2. Before turning off the engine, ref.2-way HHU quick feature programming (page 6) enable Turbo mode feature
turn on LCD remote.
3. Take the “Ignition Key” from the key cylinder.
-- Engine keeps running. --
4. Exit and secure the vehicle.
-- Engine continues running until the pre-programmed time elapsed. --
NOTE: This feature only applies to vehicles with Turbo Engines.
E. TIMER & DAILY START:
This unit can be programmed to start and run the engine every 3 / 2 hours the engine will run for the programmed
running time and then shut down.
IMPORTANT: Timer Start should be used only in open areas, never start and run the vehicle in on enclosed space as
a garage or carport.
Daily Timer Start: The feature is very useful for the driver who wants to run the vehicle punctually at the same time
next morning. Before set-up of the “Daily Timer Start”, you should pre-set the time you intend to start engine (Hour /
Minutes) by Table-2 -1 -7 set up Daily start first.
TIMER START:
Enter :
1. Turn Ignition On => Off
2. After above (1) within 15 seconds, (ref. page-6 2-way HHU quick feature programming => Enable Time start.)
p ress and hold F button of LCD remote until 3 beeps sound , release and re-press F button until LCD
show “ “ icon flash on LCD remote (see Table 3), then press button to activate Time Start. icon
illuminate on LCD display, parking light flash / siren chirp 3 or 2 times confirm. The vehicle is now programmed to
start every 3 or 2 hours
Exit : Turn Ignition On (LED and parking light flash 4 times, and siren chirp 4 times confirm exit Time Start).
(p.s. press lock or unlock button to turn off icon on 2-way remote)
Daily Start :
Enter :
1. Turn Ignition On => Off
2. After above (1), within 15 sec. ref. page-6 2-way HHU quick feature programming => Enable Daily Start ( Press
& hold F button of LCD remote until 3 beeps heard, release and re-press F button to move blinking
cursor to “ “ (see Table 3), then press button to activate Daily Start . icon illuminate on LCD
display, parking light flash / siren chirp 6 times confirm Daily Start programmed.
Exit : Turn Ignition On (LED and parking light flash 4 times, and siren chirp 4 times confirm exit Daily Start).
(p.s. press lock or unlock button to turn off icon on 2-way remote)
F. TEMPERATURE CHECK
The unit can monitor the present indoor temperature of the passenger compartment before cooling or heating your
vehicle. P ress and hold F button of LCD remote until 2 beeps sound , release and re-press F button for 4