User's Manual

Pin # Wire Color Specification
1 White (-) Dome Light Output
2 Gray Channel 3Trunk Output (-)
3 White / Blue Channel 4 (-) Aux Output
4 Pink 2 Step Unlock Output
5 Orange Ground Output (-) when armed
6 Green Negative (-) Door Trigger
7 Yellow Ignition: 12 Volt (+) with key ON
8 Violet Positive (+) Door Trigger
9 Black / Blue Channel 5 Programmable Output (-)
10 Blue Zone 2, (-) Hood / Trunk Trigger
1. Blue Wire
3. Green Wire
( - ) Lock Pulse
( + ) Unlock Pulse
( - ) Unlock Pulse
(
+
)
Lock Pulse
4. Green
Wire / Warn Away Input
3. Blue
Wire /
Zone 4
Ground Trigger
2. Black
Wire / Negative
1
.
Red
Wire / +12Volts
22 - Pin Connector
5 PIN MAIN POWER HARNESS
Door Lock Connector
QUICK START INSTALLATION GUIDE
If you are not proficient in the installation of this product or would
like a full version of the installation manual,
FOR PROFESSIONAL INSTALLATION ONLY!
WHITE: PARKING LIGHT OUTPUT
BLACK : MAIN SYSTEMS GROUND
BROWN : POSITIVE SIREN OUTPUT
RED : FUSED 12 VOLT (+) BATTERY
BLUE / BLACK: (-) HORN OUTPUT
TRANSMITTER PROGRAMMING:
Note: This mode will only retain the last 4 remote transmitters programmed.
If the transmitter memory is exceeded, the security system will start deleting
transmitters from memory in chronological order.
1. Turn the Ignition 'switch ‘OFF/ON’ 4 TIMES and stay in ON position.
“Within 15 seconds”.
2. Push the Valet switch 4 times and hold it on the 4th push until a long
chirp is heard. Then release the valet switch. You are now in the
Transmitter programming mode.
3. Press and hold any button of the transmitter until the siren responds with
a confirming chirp, indicating the signal has been stored into memory.
4. If you have additional transmitters (up to 4) that need to be programmed,
repeat step 3 for each transmitter.
Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps
& 3 parking light flashes will confirm exit.
10 Pin, Main Connector
Shock Sensor Harness
4-PIN BLACK CONNECTOR: ANTENNA MODULE
The transmitting/antenna mounting location
should be the upper left or lower left corner of
driver’s windshield. For optimum range we
suggest that the antenna be mounted as shown in
picture to the right. (Antenna tip facing up)
Warning!
Do not mount in such a manner that it obstructs
the driver’s view.
-Paging button used to page person in possession of
the 2-Way transmitter.
- Remove the protective tape backing.
- Carefully align the two-way transceiver/antenna and apply to windshield.
- Route the black connector wire behind the trim and connect to the two-way
transceiver/antenna.
- Connect the other end to the control module.
**Special considerations must be made for windshield glass as some newer
vehicles utilize a metal-shielded window glass that will inhibit or restrict RF
reception. In these vehicles, route the two ways transceiver/antenna module
away from metallic shielded window glass as far as possible.**
T X 103