User's Manual

May/31/2009
C3 RS915 REV. A 10
Press and hold the transmitter “ F ” button first until 3 chirps are heard. Then press the F Button three more times so that
TEMP appears on the remote. Within 3 seconds press button; the in-door temperature will be shown on the LCD
screen. This reading may be higher than actual ambient temperature due to the greenhouse effect and is relative only to the
inside vehicle temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press button once on the remote transmitter under the remote start mode.
2. Move the optional remote start enable toggle switch to OFF position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking light to indicate the engine has stopped.
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not start or will shut down
immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. The parking (hand) brake is released (For Turbo Timer Mode)
4. Engine is over-revved. {“Tachometer checking type” only}
5. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
6. Press button on the remote transmitter under remote start mode.
7. The system trigger.
8. The vehicle refused to start running after {3} unsuccessful attempts.
I. DISABLING THE REMOTE START SYSTEM: (If installed)
This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from being remote
started accidentally. This feature is useful if the vehicle is being serviced or stored in an enclosed area. To disable the
remote start, move the optional remote start enable toggle switch to the OFF position.
ADVANCED USER’S MODE:
C. LCD REMOTE CONTROL TRANSCEIVER OPERATION:
Enter: Press and hold F Button until beep sound respond from LCD transceiver indicate into table 1 – 5 as
below.
Exit: Press the , or button to exit this mode.
Table 1: ONE beep to confirm (Press and hold until ONE Beep is heard)
F Button LCD Display Button
Press once Backlight turns on for 5 seconds
Press twice within 5
seconds
PASS and
PASS icon flashing
Press button to arm the alarm and
bypass the sensor 1.
Press three times within
5 seconds
HIDDEN ALARM and
icon flashing
Press button to arm system and
with Hidden Alarm Function.
Press four times within 5
seconds
CAR JACK and
icon flashing
Ignition in "on" position press and hold
button for 2 seconds to activate anti
carjacking functions.
Table 2: TWO beeps to confirm (Press and hold until TWO Beeps are heard)
F Button LCD display Button
Press and hold the F MENU flashing Press button to enter the menu