User's Manual

Jun/22/2009
RST1000 OP REV.A 11
Spin down the switch
to the page 6
Press the button 1 to set the
Language to ”ENGLISH”.
Press the button and the
setting is done.
D- P6- 4. SET TO DEFAULTS:
Spin down the
switch to the page 6
Press the button 4 .
Press the button 1 &
2 at same time to set
the remote defaults.
OPERATION:
A. REMOTE TRANSMITTER OPERATION:
Transmitter Button System Function Remark
1 Lock Doors & Arm System / Button 1
- Arm and Bypass Zone 4. Shock Sensor Press twice within 3 seconds
then Arm System and Hidden, (Silent) Alarm
Function
Press within 3 seconds
Car Locator Upon armed
(3-second) Panic function Press and Hold for 3 seconds.
To cancel.
+ Silent Arming / Disarming Ignition in "off" position.
+ (2-second) Active Anti Car-Jacking Mode. Programming
required
Ignition in "on" position press and
hold for 2 seconds
2 Unlock Doors & Disarm System / Button 2
-
--
- Two Steps Door Unlock & Disarm System Press twice within 3 seconds.
3 (3-second) Trunk Release (Channel 3) Press and Hold for 3 seconds
- Passive Arming By-pass While the system Disarmed.
4 Turn ON & Off The Remote Start / Button 4 .
-
--
- Safety Start. Programming required Press twice within 3 seconds.
+ Channel # 4 Timer Output Programming required
+ Channel # 5 Timer Output Programming required
+
Channel # 6 Timer Output Programming required
II
IIII
II Switching code For 2nd Car Operation. For regular remote transmitter
Button Function Selection For Two way Remote transceiver
Confirm Button / Back to Main Page For Two way Remote transceiver
Feature Selection For Two way Remote transceiver
B. LED display:
LED Function LED Function
Off Disarmed 1 flashes... pause Zone 1 / Trigger on Hood