User's Manual

D. Cut this wire and connect the ignition cylinder side to terminal 30 of a P&B VF45F11 or equivalent relay.
E. Connect the cathode (striped) side of a 4003 series diode to this same wire, and connect the (non striped) side to the negative
safely input wire (WHITE/ BLACK) (H6/19) of the Remote Start Unit.
F. Connect terminal 86 of the relay to a fused + 12 volt constant battery source.
G. Connect terminal 87 of the relay to the Chime Module side of the previously cut wire in step D.
H. Connect terminal 85 of the relay to the Drivers Door side of the pin switch wire previously cut in step B.
Note: A second 4003 series diode may be required to maintain the integrity of the hood open, shut down circuit. If this is the
case, it must be installed as shown in the diagram above. The anode (Non Stripped) side must be connected to the WHITE/
BLACK wire (H6/19) of the Remote Start Unit. The cathode (Striped) side must be connected to the hood pin switch. If the hood
pin switch is also used for an alarm trigger input, be certain to use the dual diode assembly packaged with the Remote Start Unit
as shown in this installation guide.
METHOD 2
Ignition Key In Sensor
Switch Closes with Key
In Ignition Cylinder
Connected to (-) Negative
Safety Input Wire
White/ Black
(
H10/14
)
To Hood Pin Switch
Safety Shut Down (
H10/1
)
1N4003
To connect to the key in sensor circuit as shown for method 2:
A. Locate the control wire that connects the driver’s door pin switch to the key in sensor switch.
B. Cut this wire and connect the ignition cylinder side to chassis ground.
C. Locate the key in sensor switch wire that connects the chime module to the ignition cylinder.
D. Cut this wire and connect the ignition cylinder side to the Remote Start Negative Safety Shut down wire WHITE/ BLACK
(H6/19), using a 4003 series diode as shown above.
Note: A second 4003 series diode may be required to maintain the integrity of the hood open, shut down circuit. If this is the
case, it must be installed as shown in the diagram above. The anode (Non Striped) side must be connected to the WHITE/ BLACK
wire (H6/19) of the Remote Start Unit. The cathode (Striped) side must be connected to the hood pin switch. If the hood pin switch
is also used for an alarm trigger input, be certain to use the dual diode assembly packaged with the Remote Start Unit as shown in
this installation guide.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:-
(1) This device may not cause harmful interference.
(2) This device must accept any interference received : including interference that may cause undesired
operation.
Note: The manufacturer is not responsible for any radio of TV interference caused by unauthorized modification to this equipment.
Such modification could void the user’ authority to operate the equipment.