User's Manual

5
Door lock
before start
Door lock after
shut-down
Door lock before
start and Door
lock after
shut-down
Without this
feature
6
+
Press
button
=
Activate Remote
Start.
Press
-
button
=
Activate Remote
Start.
Press
+
button
=
Activate Remote
Start.
7
+
H6/4 White/Blue
wire=
1 pulse activate
H6/4 White/Blue
wire =
2 pulse activate
H6/4 White/Blue
wire =
3 pulse activate
8 +
AUTOMATIC
TRANSMISSION
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
SAFE START (Child safety mode)
Factory defaults setting to press the
button once to start the vehicle.
Programming this feature to eliminate an accidental remote start,
1. The user presses the transmitter
buttons “twice” within 3 seconds to start the vehicle. or
2. The user presses the transmitter and buttons at the “same time” to start the vehicle.
START FEATURE: “E” PROGRAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 11 times (holding in on the 11
th
push) until five chirps with one long chirp is heard then release the valet
switch. You are now in the Start feature “E” programming mode.
3. Press and release the transmitter button corresponding to the feature you want to
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
Exit the programming mode. (3 long chirp & 3 parking light flashes to confirm
this exit.)
2
+
Tachometer
Check type (3A)
Voltage check
type (go to 3B)
Timer checking
type (go to 3B)
Data Bus
Interface
Mode**
A> RPM learning – see RPM Learning page 20
3
B>
Start Crank
Time:
0.6-second
0.8-second (2 chirps), 1.0-second (3 chirps), 1.2-second (4
chirps), 1.4-second (5 chirps), 1.6-second (6 chirps),
1.8-second (7 chirps), 2.0-second (8 chirps), 3.0-second (9
chirps), 4.0-second (10 chirps),
4
Low check level
Hi check level
5
Start or Stop the system for TESTING & ADJUSTMENT
6
+
“TEST” Mode for
Zone 2 / instant
trigger & Zone 3 /
Door trigger
“TEST” Mode for
Zone 1 & Zone 4
(2 Stage Shock
Sensor)
7
+
+ 50 RPM
DBI ONLY
No RPM learning
8
+
- 50 RPM
DBI ONLY
No RPM
Learning or <
50RPM
Exit: Press the button on the transmitter. 3 long chirps & 3 parking light flashes will confirm exit.
** This will be used when connected to an Autopage CI3 compatible Two-way data module that will recognize
the tach signal from the vehicle. This signal will need to be learned in the same manner as the analog
tachometer wire. If this learned value needs to be adjusted, use steps 7 and 8 of this programming table
IMPORTANT NOTE:
You must program the “Tach Signal” before trying to remote start.