User's Manual

ALARM FEATURE “A” PROGRAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 3 times (holding in on the 3
rd
push) until one chirp with one long chirp is heard, and then release the
valet switch. You are now in the Alarm feature “A” programming mode.
3. Press and release the transmitter button corresponding to the feature you want to program.
a. The siren chirps and LED pause will indicate previously setting.
b. The factory default settings is always [1] LED flash, [1] chirp.
4 Depress the transmitter button to change the feature. Simple keep re-depressing the transmitter button until the system
advances to your desired setting.
4. Press the transmitter button corresponding to the feature you want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulses
Three Chirps /
LED three pulses
Four Chirps /
LED four pulses
1
Active arming
Passive arming
without passive
door locking
Passive arming
with passive door
locking.
2
Automatic Rearm
off
Automatic
Rearm on
3
Instant Door Ajar
error chirp
45 seconds
delay Door Ajar
error chirp.
4
All Confirmation
chirps on
Siren
Confirmation
chirp on only
Horn
Confirmation
chirp on only
All Confirmation
chirps off
5
+
Panic with
Ignition off
Panic with
Ignition on & off
Panic with
Ignition on & off.
Panic with No
time limit.
Without Panic
function.
6
+
Without Car-jack
mode
Active Car-jack
mode
Passive Car-jack
mode
7
+
With Dome light
turns on & off
after ignition off
(45 second door
by-pass)
With Dome light
turns on after
ignition off (45
second door
by-pass)
Without this
feature
8
+
Lock/Arm &
Unlock/Disarm
Confirmation
Chirp
Lock/Arm
Confirmation
Only
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
45 seconds Delay Door Ajar Error Chirp:
This feature controls the error chirp that is generated if the system is armed with the door trigger active. This is useful in a vehicle
that has a long dome light delay after the door has been closed. If the system is armed before the dome light has turned off, the
security system will generate the door trigger error chirp. Use this feature to disable the door open error chirp.
With Dome light turns on after ignition off:
Some vehicles turn on the dome light when ignition key is turned off. After remote start, with alarm on, a false alarm may occur
when the run time elapses and the dome light comes on. To prevent this from happing, program Alarm Feature
A-7
to “With Dome
light turns on after ignition off (45 second door by-pass)”.
ALARM FEATURE “B” PROGRAMMING:
1 Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in the OFF position.
2 Push the Valet switch 5 times (holding in on the 5
th
push) until two chirps with one long chirp is heard and then release the
valet switch. You are now in the Alarm feature “B” programming mode.
3 Press and release the transmitter button corresponding to the feature you want to program.
Press
Transmitter
Button
One Chirp / LED
one pulse
Factory Default
Setting
Two Chirps /
LED two pulses
Three Chirps /
LED three pulses
Four Chirps /
LED four pulses