User's Manual

The WHITE/BLACK wire provides an
instant shutdown for the remote start,
whenever it is grounded. Connect the
wire to the hood pin switch previously
installed. This wire must be routed
though a grommet in the firewall and
connected to the hood pin switch. This
will also act as a hood trigger for the
alarm system
To: White/Black Wire /
Negative safety & Hood
Trigger
Hood Pin
Important! This connection is a safety wire and must be connected as shown and tested as specifiled. Failure to do so may
result in personal injury or property damage. See detail of wiring in the following diagram. This wire may also be used if the
vehicle brake light circuit switches ground to the brake lights. An isolation diode must be used for ground switched brake light
circuits and must be connected to the output of the brake switch.
H6/20 ORANGE WIRE – (-) 200mA Grounded Output When Armed –
This wire will become grounded when the alarm is armed. The current capacity of this wire is 200mA. This output can control
starter disable, when an intrusion is detected and the system is triggered. The vehicles prevent from any unauthorized starting.
87
87a
85
30
86
IN4003 Diode
H6
/
20: ORANGE wire
from control module
“Start”
“On”
Purple wire
X
Cut
Yello wire
White wire
“Acc”
“Off”
Starter
H1/1 VIOLET wire (Starter output)
form Heavy Gauge wire harness
Red wire to
Ignition Switch
H2. RS232 C I 3 SERIAL TWO-WAY DATA PORT CONNECTION:
This connector is to be used for Serial Data communications with idatalink modules by Auto Page only!
DO NOT CONNECT THIS TO ANY OTHER WIRING!
This connector will transmit digital codes to operate all functions of Autopage data modules. When these modules are used, no
other data bus connections need to be made to the RS-730. The Data Bus module will receive its commands directly from the
CPU of the RS-730. This will provide greater theft protection as well as aid in the installation of this product. The RS-232 serial
harness is provided with all Autopage serial data modules and is not included with the RS-730. This two-way data port has been
designed for use with all C I 3 compatible components. C I 3 Telematics system is available at any authorized Autopage dealer.
This port will only operate correctly with Autopage C
I 3 idatalink Modules .
H4. 3 PIN DOOR LOCK CONNECTOR: (Maximum 500mA Output)
Blue
Wire
Green Wire
( - ) Lock Pulse
( + ) Unlock Pulse
( - ) Unlock Pulse
(
+
)
Lock Pulse
Red(not used)
NEGATIVE TRIGGER DOOR LOCK SYSTEM
Red (not used)
Blue Wire Door Unlock
Green Wire Door Lock
Locking
Master
Switch
To Exiting
Door Lock Relay
+12V
Master Door
Lock Switch
X
X
Splice
Splice
Cut the Existing
Lock Wire
To Door
Lock
Motor
To Slave Door
Lock switches
Cut the Existing
Unlock Wire
3 Pin Plug
To Alarm
5-WIRE ALTERNATING DOOR LOCK
30
86
87a
85
87
30
86
87a
85
87
Red +12V
Green Wire
Blue Wire
POSITIVE TRIGGER DOOR LOCK SYSTEM
Blue Wire Door loc
k
Green Wire Door Unlock
Locking
Master
Switch
To Exiting
Door Lock Relay
+ 12V
Red (not used)