User's Manual

Ignition Trigger
Ignition switch is illegally turned on
(Zone 5)
System trigger
Remote Transmission
You are transmitting the signal to
control unit
In – Range Indicator
Your are within the remote control
range.
Anti Car-Jack Mode
Activate the anti car-jacking mode
Icon flash under check mode
Engine Cranking
Your vehicle engine Cranking by
remote control
Engine Running
Your vehicle's engine is running
Timer Control Start
Engine start automatically every 2 or
3 hours.
Daily Start
Engine start automatically at the same
time next day
Temperature Start
Engine start automatically when reach
programmed temperature.
Turbo Timer
Turbo timer was set up
Manual Gear
Engine Start Memorizing for the car
with manual gear was set up
Activate Channel 3 (Trunk Release).
Activate Channel
3
Activate Channel
4
12:00
Time Monitor
12:00
Alarm Clock
You have set morning call alarm
Parking Meter
Reminder when time is up for parking
Low Battery
You have to replace the battery of
remote control.
Melody Mode
Remote Control alert user through
melody sound
Vibration Mode
Remote Control vibrates when the
system is triggered
C. LCD REMOTE CONTROL TRANSCEIVER OPERATION:
Enter : Press and hold F Button until beep sound respond from LCD transceiver indicate into table 1 – 5
as below.
Exit: Press
, or button to exit this mode.
Table 1: one beep to confirm
F Button LCD Display
Button
Press once Backlight turns on for 5 seconds
Press twice within 5
seconds
PASS and
PASS icon flashing
Press button to arm the alarm
and bypass the sensor 1.
Press three times
within 5 seconds
HIDDEN ALARM and
icon flashing
Press
button to arm system and
with Hidden Alarm Function.
Press four times within
5 seconds
CAR JACK and
icon flashing
Under ignition in "on" position press
and hold
button for 2 seconds to
activate anti car jacking functions.
Table 2: two beeps to confirm
F Button LCD display
Button
Press and hold the F
Button for 2 second
MENU flashing Press button to enter the menu
mode
2