User's Manual

6
Program Mode -
Switching code for 2nd / 1st Car Operation Press within 5 seconds
Program Mode -
Melody / Vibration Mode Press within 5 seconds
Program Mode -
Power Save Mode Press within 5 seconds
LCD screen lamp turns on for 5 seconds.
- +
Clear the Flash Icon and Melody Sound Press within 3 seconds
1. Second Vehicle Security Operation: Your remote transmitter can be utilized to control a second vehicle’s
Auto Page security system. To program the remote control transmitter to a second vehicle, follow the
instructions for Transmitter programming. All programming parameters are the same except for the following:
For Regular Remote Control Transmitter:
1. Prior to pushing any button on the transmitter. Press the Select II button first on the standard transmitter.
2. Once II button is pressed the LED on the transmitter will illuminate for 3.5 seconds. While the LED is
illuminated, press the button for the function you want to operate on the standard remote transmitter to
control a second vehicle security system.
For 2-way LCD Remote Control Transceiver:
2nd Car Operation: While the “II” icon display on the LCD screen, you can remote control and communicate
with a second Autopage AM frequency security system. It has two short “beep” sounds while pressing any
button of the LCD screen transceiver
1. Press and hold all four remote control buttons simultaneously unit one long beep is
heard. LCD Programming has now been entered.
2. Within 5 seconds press and hold button until two beeping sounds are
heard and
the “II”
icon will display on the LCD screen to indicate the second transceiver pin
code has been initiated.
3. To exit
programming mode, take no action for five seconds. The remote control will
generate two long beeps to indicate programming mode has been exited.
Back to first Car Operation:
This will allow you to control and communicate with the first vehicles security system.
1. Press and hold all four remote control buttons simultaneously unit one long beep is
heard. Programming has now been entered.
2. Within 5 seconds press and hold button until one beep sound is heard.
3. To exit programming mode, take no a
ction for five seconds. The remote control will
generate two long beeps to indicate programming mode has been exited.
Vibration / Melody Mode:
Vibration mode is useful when you are in a noisy place and it is difficult to hear the beep sound from the remote
control. In this mode the unit will vibrate if your security system is triggered.
1. Press and hold all four remote control buttons simultaneously until
one long beep is
heard. Programming has now been entered.
2. Within 5 seconds, press the butt
on to select the mode of vibration or melody, the
icon will displayed
on the LCD screen to show the LCD remote transceiver is in
vibration mode.
3. To exit programming mode, take no action for five seconds. The remote control will
generate two long beeps to indicate programming mode has been exited.
Power Save Mode:
While in the power save mode, the LCD remote transceiver will “sleep” until a button is pushed. This will extend
the life of battery. When power save mode is “ON”, the remote control will wake up periodically to check for
messages from the security module.