User's Manual

5
BATTERY REPLACEMENT:
A 1.5V type AAA Alkaline battery powers the Remote
Transmitter. When the power of the battery weakens a
icon shall be displayed on the LCD screen.
When the old battery is replaced with a new one, there
will be beep sounds indicate the power is up.
Note: Press the button two times when the
battery compartment is empty, and then insert the
new battery.
THE REMOTE LCD ICONS WITH FUNCTION:
Door Lock
Your vehicle doors are locked.
Door Unlock Your vehicle doors are
unlocked
Start Mode
Your vehicle is running
Valet Mode
All the function shall be temporarily on
hold.
Remote Transmission You are
transmitting the signal to control unit
In – Range Indicator
You are within the remote control range.
Trunk Release Trunk open. Trunk
symbol only.
Low Battery
You have to replace the battery of
remote control.
Vibration Mode
Remote Control vibrates when the
system is triggered
Ignition On
Power Save Mode
Save the battery power
Driver paging
Someone is paging you in front of your
vehicle. **
** Press the valet switch in the vehicle with the Ignition OFF to page the driver carrying the two-way
remote control.
PROGRAM MODE FOR LCD REMOTE CONTROL TRANSCEIVER:
Press and hold all four remote control buttons simultaneously unit one long beep is heard. LCD
Programming has now been entered.
Transceiver Button System Function Remark
Note: If the system is interfered by stronger radio
frequency around, sources of high voltage electric
power or such obstacles like tall buildings and so on, the
transmission range may get shorter as the system uses
low output powered frequency.
AAA