User's Manual

feature is especially useful in cold climates where the only means to keep the engine and engine fluids
warm is to periodically start the engine.
If the system is set up to start in temperature mode, the system can be programmed to automatically start
the vehicle engine whenever the temperature inside the vehicle reaches or drops below the
preprogrammed temperature level. The system will monitor the air temperature every 3 (2 /1) hour and will
only start the engine during extreme cold temperatures.
WARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle-starting device.
A running engine produces dangerous carbon monoxide fumes, which can be harmful or fatal if prolonged
exposure occurs. DO NOT remote start the vehicle if it is garaged.
Timer Start Operation:
1. Turn the ignition key on then off. Within 15 seconds …..
2. Press the
button first, with 3 seconds press the button.
3. The parking lights will flash and the siren will chirp 3 times
indicating the timed start mode is activated.
Your set the timer icon or the temperature icon for engine start
flashes for approx. 3 seconds on the LCD screen. After 3 seconds
the
icon stays displayed on the LCD screen
Timer Start Temperature Start
Daily Timer Start Operation: The feature is very useful for the driver who wants to run the vehicle
punctually at the same time next morning. Before set-up of the “Daily Timer Start”, you should set you time
for engine start.( see Timer Setting /
Timer set-up for “Daily Timer Start, page 16)
1. Turn the ignition key on then off. Within 15 seconds …..
2. Press the
button first, with 3 seconds press and hold the button for three
seconds.
3. The parking lights will flash and the siren will chirp 6 times indicating the daily timed
start mode is activated.
Your set time for the next day engine start flashes for approx. 3 seconds on the LCD
screen. After 3 seconds the
icon stays displayed on the LCD screen.
Daily Timer Start
Cancel the timer start: To cancel the timer start do one of the following;
1. Start the vehicle manually with the use of the ignition key.
2. Remote starts the vehicle using your keychain RF transmitter.
F. TEMPERATURE CHECK
You can monitor through the LCD screen, the present indoor temperature of the
passenger compartment before cooling or heating your vehicle.
Press the transceiver
button first, within 3 seconds press the ( ) button; the
in-door temperature will be shown on the LCD screen. This reading may be higher than
actual ambient temperature due to the greenhouse and is relative only the inside vehicle
temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press
button twice on the remote transmitter under remote start mode.
2. Move the optional remote start enable toggle switch to OFF position. (If installed)
3. Press the brake pedal.
The vehicle will shut down and turn off the parking light to indicate engine stopped.
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not start or will shut
down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. Engine is over-revved. {“Tachometer checking type” only}
4. The pre-programmed run time (5 / 10 /20 / 30 minutes) has elapsed.
5. Press
button twice on the remote transmitter under remote start mode.
6. Move the optional remote start enable toggle switch to OFF position. (If installed)
8. The vehicle refused to start running after {3} unsuccessful attempts.
I. DISABLING THE REMOTE START SYSTEM: (If installed)
This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from
being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an
enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the
OFF position.
9