User's Manual

System Disarm
Hood Trigger
Trunk Trigger
Doors Trigger
Ignition Trigger
Sensor 1 Trigger
Sensor 2 Trigger
CLEAR THE FLASH ICON: Press the button 3 times
within 3 seconds will clear the flash icon on the LCD screen
transceiver.
TAMPER DISARMING: If alarm triggered, upon disarm the
system, siren chirp 4 times, parking light flash 3 times.
PATHWAY ILLUMINATION: This feature turns the parking light “ON” for 30 seconds upon a unlock
signal and for 10 seconds upon the lock signal
TWO STEPS DOOR UNLOCK: This feature will independently unlock the driver’s door only when
disarming the security system. Pushing the
button a second time within 3 seconds will unlock the
other doors.
AUTOMATIC RE-ARM: If this feature is selected, the security system will automatically re-arm itself in
60 seconds after disarming with remote transmitter. Automatic rearm will cancel if any door is opened
before the 60 seconds timer has elapsed.
J. VALET MODE: (System in Disarm or Valet mode)
Activate Valet Mode:
1. Turn the ignition to “Off” position and open any door.
2. Press and hold
+
3. The door locks will lock and unlock. Release the button
4. The LED will begin to flash every 5 sec. indicating that the system is in valet mode
Exit Valet Mode:
1. Turn ignition 'Off' and open any door.
2. Press and hold
+
3. The door locks will lock and unlock. Release the button
4. The LED will be off indicating that the system is out of Valet mode.
Remote Door Lock
Remote Door Unlock
K. CAR LOCATOR
Under armed mode, press the button to active car locator function. The siren will
chirp 6 times. The parking light will flash 12 times, for you to easily locate your car.
L. PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency.
1. Press and hold the
button for 3 second. The alarm will immediately sound and the
icon will display on the LCD screen.
2. During panic mode, the normal function of this transmitter button will be suspended.
The transmitter
and buttons can be used to lock and unlock the door (if the
option is installed), however once the
button is pressed, the vehicle’s starter
disable device, (where installed) will be enable allowing the vehicle to start.
3. To stop the alarm, press and hold the transmitter or button on the transmitter again for 3 seconds.
Also if any transmitter buttons other than
or button is pressed and released, the panic mode will
be turned off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
5