User's Manual

7 +
Standard Horn
output Function
Horn output for alarm
trigger, panic and
car- finder only
8 +
Standard horn
pulse
“SOS” type
S-S-S - L-L-L - S-S-S
S-L-S-L S-S-S - L
Five Chirps /
LED five pulses
Six Chirps /
LED six pulses
S-M-L-S-M-L S-S - L - S-S
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds to exit the program mode and the siren will
chirp three long chirps.
ALARM FEATURE “II” PRORAMMING:
1 Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2 Push the Valet switch 4 times and holding in on the 4
th
push until two chirps with a long chirp is hearing
then release the valet switch. You are now in the Alarm feature ‘II’ programming mode.
3 Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp / LED
one pulse
Factory Default
Setting
Two Chirps / LED
two pulses
Three Chirps / LED
three pulses
Four Chirps / LED
four pulses
0.8 second door
lock & unlock
3.5 second door
lock & Unlock
0.8 second Lock,
0.35 second Unlock
0.8 sec. dbl Lock,
0.8 sec. dbl Unlock
1
Five Chirps = 0.8 second Lock, double 0.8 second. Unlock
Six Chirps = Double 0.8 second Lock, 0.8 second Unlock
Seven Chirps = Door lock with “Comfort Feature”
2
Ignition controlled
door locks &
unlocks
Ignition controlled
door locks only
Ignition controlled
door unlocks only
Without ignition
controlled door
locks & unlocks
3 Pathway illumination
feature “off”
Parking light turns
“on” for 30- second
upon an unlock
signal
Parking light turns
“on” for 30- second
upon an unlock
signal & 10-second
upon a lock signal.
4 Horn Chirp
Output16 mS
Horn Chirp Output
30 mS
Horn Chirp
Output40 mS
Horn Chirp
Output10 mS
5
+
The Vehicle without
Turbo Timer mode
Press
and
buttons at the same
time to control
Engine running
three minute.
Press
and
buttons at the same
time to control
Engine running five
minutes
Press
and
buttons at the same
time to control
Engine running ten
minutes
6
+
Enable the out of
range check
Disable the out of
range check.
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds to exit the program mode and the siren will
chirp three long chirps.
Comfort Feature:
Some Vehicles have a special “COMFORT feature”. When you lock the door with the key, you just have to
keep on turning the key on the door about 5 or 7 seconds and the window will close directly.
If your vehicle with “COMFORT feature” and you wish the door being locked and the window being closed
automatically at the same time by remote control, you can set the alarm feature II-1 “with comfort feature
ALARM FEATURE “III” PRORAMMING:
1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2 Push the Valet switch 6 times and holding in on the 6
th
push until three chirps with a long chirp is
hearing then release the valet switch. You are now in the Alarm feature ‘III’ programming mode.
3 Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulses
Three Chirps /
LED three pulses
Four Chirps /
LED four pulses
15