User's Manual

It is useful when you are in a noisy place and difficult to hear beep sound from the
remote control as the remote control in this mode, vibrates itself if your security system is
triggered.
Press the
button first, within 3 seconds press and hold the button to select the
mode of melody (
) / vibration ( ) or melody with vibration ( ) , the / icon will
displayed on the LCD screen.
7. Enable / Disable Bi Sound While Pressing Button:
It has a short “bi” sound while pressing the button of the LCD screen transceiver
If you want mute the “bi” sound mute always while press button. Press the
button first, within 3
seconds press and hold the
(Bi) button for 2 seconds to disable the “bi” sound.
8. Low Battery Indication:
When the power of the battery weakens, it has two short “bi” sound and flash
icon while pressing the
button of the LCD screen transceiver.
9. Set Up Fixed Count Down Timer:
1. Press the
button first, within 3 seconds press and hold the ( ) button for 2 seconds, the
LCD screen will shows
icon and timer (ie. 0:10) ,
2. Press the
( ) button again showing next order time on the screen ( ie.0:20), press them again
(ie.0:30)…..and so on.
3. Leave the buttons starting count down then
icon flashes
Note: 1.The count down period is fixed as 10 minutes, 20 minutes, 30 minutes, 1 hour, 1.5 hours and 2
hours maximum.
2.When count down timer showing 0:00 means to turn off the timer.
3. Press
button for real time indication when the timer is counting down.
10. Out Of Range Indication:
If this feature is selected, the system will automatically check the range every 30 minutes.
1. If user is within the range, the
icon will display on the LCD screen.
2. If user is out of range, it has five short “bi” sounds and the
icon will disappear on the LCD screen.
Note: Programming “Out Of Range Indication” will decrease the life expectancy of battery.
11. Illumination
Illumination for the LCD display can be programmed “On” or “Off”. When programmed “On”, the LCD will
illuminate every time the remote control receives a page or transmits a command.
Press the
button twice, within 3 seconds press and hold the button for 2 seconds. The remote will
beep once for “On”, twice for “Off” and the light will turn on/off with each press.
Note: Programming “illumination “On” will decrease the life expectancy of battery.
12. Second Vehicle Security Operation:
Your remote transmitter can be utilized to control a second vehicle security system, To program the
remote control transmitter to a second vehicle, follow the instructions for Transmitter programming. All
programming parameters be the same except for the following:
For 1-way Remote Control Transceiver:
1. Press the button first within 3 seconds press and hold and buttons at the same time for 2
seconds
2. Once button is pressed, the LED on the transmitter will illuminate for 3 sec. to indicate second
vehicle transmitter operation.
3. While the LED is illuminated, press any button on the transmitter to control the 2
nd
car security
system or alarm function (arm/ disarm/ trunk/ remote start)
Note: Button functions are the same for the second car as they are for the first car.
For 2-way LCD Remote Control Transceiver:
2nd Car Operation: you can remote control and communicate with a second vehicle security system.
1. Press
first, within 3 seconds press and hold and buttons at the same time for 2 seconds
with two beeping sound and the “
” icon will display on the LCD screen to
indicate the second transceiver pin code has built-in.
2. While the “
” icon display on the LCD screen, you can remote control and
communicate with a second vehicle security system. It has two short “bi” sounds while
pressing the button of the LCD screen transceiver.
Back to 1st Car Operation:
12