User's Manual
Table Of Contents
- Door Lock
- Door Unlock
- Your vehicle doors are unlocked and the system is Disarmed
- Armed Mode
- Hidden Alarm Mode
- Activate the car jacking mode
- Valet Mode
- Remote Transmission
- You are transmitting the signal to control unit
- In – Range Indicator
- Hood Trigger
- Trunk Trigger
- Door Open Warning
- Sensor Trigger
- Engine Cranking
- Engine Running
- Timer Control Start
- Engine start automatically at the same time next day or every 2 / 3-hour.
- Indoor temperature of your vehicle
- Activate Channel 4
- Activate Channel 6
- You have set morning call alarm
C7
Activate Channel 7
Time Monitor
Alert Alarm
You have set morning call alarm
Count Down Timer
Reminder when time is up for
parking
Power Save Mode
Save the battery power
Melody Mode
Remote Control alert user through
melody sound
Vibration Mode
Remote Control vibrates when the
system is triggered
Button Lock
Disable the transmission function
temporarily
Driver paging / Lose and Found
Someone is paging you in front of
your vehicle
C. PROGRAMMING OF THE LCD REMOTE TRANSMITTER:
Transmitter Button Description Operation
(1 second) LCD screen lamp turns on for
5 seconds.
Press and hold for 1 second
1 melody sound to confirm
enters.
(3 seconds) Timer Programming Mode. Press and hold for 3 seconds
2-melody sounds to confirm
enter.
(5 seconds) Power Save Mode Press and hold for 5 seconds
1 melody sound to confirm
enters.
- -
Clear the Flash Icon and Melody Sound
on the LCD Screen Transmitter
Press within 3 seconds
- (2-second)
Button Lock (
) enable / disable
Press within 3 seconds
- (2-second)
Melody (
) / Vibration ( ) Mode
Press within 3 seconds
- (2-second)
Program Count Down Timer
( )
(10-Minute / 20M / 30 M /1Hour /1.5H /
2.0H)
Press within 3 seconds cycling
*leave the buttons starting count
down then flashes
- (2-second)
Enable / Disable Bi Sound (Bi) While
Pressing Button
- -
(2-second)
Illumination On /Off Press within 3 seconds
- + (2-second)
Switching code for 2nd / 1st Car
Operation
Press within 3 seconds
1. Screen Lamp ON: Press and hold the button one second, with one melody sound and the LCD
screen lamp will turns on for 5 seconds
2. Power Save Mode: While the power save mode, the LCD remote transceiver uses “0”
current to save the battery power.
Entry: Press & hold the
button for 5 seconds, with one melody sound and
icon on the LCD screen to indicate entry the “power save mode”.
Exit: Press any button of the LCD remote transmitter to exit the “Power Save Mode”.
3. Clear the Flash Icon and Melody Sound: Press the button 3 times within 3 seconds will clear the
flash icon and melody sound on the LCD screen transceiver
4. Stop The Trigger Melody Sound:
While triggering the alarm the LCD screen will alert user through
melody sound and flashing trigger icon, press any button on the LCD remote transmitter to stop melody
sound
only.
5. Button Lock: It is useful if you want to disable the transmission function of the remote
control temporarily to prevent from any inadvertent pressing of buttons by others. Press
the
button first, within 3 seconds press and hold the ( ) button for 2 seconds to
activate or cancel the button lock function, the
icon will displayed on the LCD screen
to show the LCD remote transmitter is on “Button Lock”.
6. Vibration / Melody Mode:
11