User's Manual

ManualsBrandsAdvance Security ManualsAutomotiveCar Alarm Transceiver

TRX970

OPERATION MANUAL

Summary of content (9 pages)

PAGE 1
TRX970 OPERATION MANUAL 1
PAGE 2
REMOTE TRANSCEIVER (TX) A.
PAGE 3
B. CHARGE THE BATTERY Power by built-in 3.7V lithium polymer battery, if the OLED screen display low battery or is flash, charge your remote transceiver. While the battery of the Remote Transceiver is under the battery charging, you can push the ” ” button to check charging condition. AC Power Supply The remote transceiver equipped AC POWER SUPPLY / AC ADAPTOR (Output Voltage: 4.2VDC – 5.5VDC and with same USB plug), then you can charge the battery indoors.
PAGE 4
Spin down the switch to the page 1 Spin down the switch Spin down the to the page 2 Spin down the switch to the page 5 Spin down the switch to the page 3 switch Spin down the Spin down the switch to the page 4 switch resume to main page. to the page 6 E- P1- 1. “BUTTON BI” SETTING: Example: Set the “Button Bi Disable”. It has a short “bi” sound while pressing the button of the remote transceiver Spin down the switch to the page 1 E- P1- 2.
PAGE 5
E- P1- 4. “DEMO MODE”: Spin down the switch Demo movie playing Press the button 4 to exit. start Demo movie to the page 1 Press the any Button to E- P2- 1. “POWER SAVE” SETTING: Example set the “Power Save Enable”. While the power save mode, the LCD remote transceiver uses “0” current to save the battery power. Spin down the switch to the page 2 Press the button 1 to change the setting. Press the button 1 and it will display previously setting. Press the button and the setting is done.
PAGE 6
Press the button 1 and the “-” flashes for setting. Spin down the switch to set the “0”. Press the button 3 and the setting is done. D- P2- 4. “LIGHTING FOR OLED” TIMER SETTING: Example: set the OLED display from 2 seconds to 3 seconds. Spin down the switch to the page 2 Press the button 4 and it will display previously setting D- P3- 1.
PAGE 7
Press the button 2 to set the ”minute” digit to “30”. Press the button 3 to set the alert alarm timer and the icon will flash on the main page. Push the button Press the button 2 to set off the alert alarm timer or press any button to stop alarm while alert alarm timer trigger While the icon is flashing or When alert alarm timer trigger, the screen will display alert alarm timer C- P3- 3.
PAGE 8
D- P4- 1. “NAME OF TX ” SETTING: Spin down the switch to the page 4 Press the button 1 and the “-” flashes for setting. Example Set Name of Transceiver 1 to MIKE Press the button1 and the “-” flashes for setting. Spin down the switch to set the “M”. Press the button 1 and the “-” flashes for setting. Spin up the ” switch to set the ”I”. Spin down the Press the button 1 and the “-” flashes for setting. Spin up the switch to set the ”E”. Press the button 3 and the setting is done.
PAGE 9
D- P6- 4. SET TO DEFAULTS: Spin down the switch Press the button 1 & 2 at same time to set the defaults. Press the button 4. to the page 6 OPERATION: A. REMOTE TRANSMITTER OPERATION: Transmitter Button 1 (3-second) + + (2-second) 2 - 3 (2-second) - 4 + + + II System Function Lock Doors & Arm System / Button 1 Arm and Bypass The Zone 4.