User's Manual

CARLINK IVU

OPERATION MANUAL

HHU CPU: 28pin 2K ROM SIZE. HT48R30A SSOP

IVU CPU: 14pin 1K ROM SIZE. PIC16F630 SOP

1. Transmitter programming: It only retain 4 transmitter programmed. If the memory is

exceeded, the system will start to delete transmitters from memory in chronological order.

2-WAY 46-BIT (HOPPING CODE.)

Hold SW in IVU until LED flashing (0.25” ON,0.25”OFF), you are in the transmitter

programming mode. Within 5", press BTN in TX1, LED on 1”; press BTN in TX2,LED on

2”..indicating the signal have been stored into memory.

Transmitter

Button

System Function Remark

Lock Doors & Arm System

Unlock Doors & Disarm System

(1.5-second)

Trunk Release Press and Hold for 1.5

seconds.

Car Locator

Panic Function Press and Hold for 3 seconds.

Activate or Turn Off The Remote Start Operate as manual

NOTE: a. 2 code must be the same, then you can use.

b. Example:2-WAY 46 bit, when you use. Compare with hopping code is

necessary.

c. RF DECODE :

1. Decode as following:

1) Each Bit must shorter than 3000us.

2) 0000, FFFF without decode

3)Compare Code with EEprom.

d. exit: leave it for 5” .

2.HHU reaction

2.1 LOCK: 1 CHIRP, LOCK ICON ON

2.2 UNLOCK: 2 CHIRP, UNLOCK ICON ON

2.3 TRUNK: MELODY, TRUNK ICON ON

2.4 REMOTE START: 1 CHIRP, START ICON FLASH

2.5 REMOTE STOP: 3 CHIRP, START ICON OFF

2.6 CAR LOCATOR: MELODY, CALRLOCATOR ICON ON

2.7 PANIC: MELODY, PANIC ICON ON

3.HHU after 2”,LCD OFF, it is SLEEP MODE, it doesn’t accept any commend.

REMOTE START as well.

PAGE 1
CARLINK IVU OPERATION MANUAL HHU CPU: 28pin 2K ROM SIZE. HT48R30A SSOP IVU CPU: 14pin 1K ROM SIZE. PIC16F630 SOP 1. Transmitter programming: It only retain 4 transmitter programmed. If the memory is exceeded, the system will start to delete transmitters from memory in chronological order. 2-WAY 46-BIT (HOPPING CODE.) Hold SW in IVU until LED flashing (0.25” ON,0.25”OFF), you are in the transmitter programming mode. Within 5", press BTN in TX1, LED on 1”; press BTN in TX2,LED on 2”..
PAGE 2
4.Relationship between TRUNK & Remote Start : 4.1 It will send code twice while open TRUNK & REMOTE START, CODE(A) -> LOW 2” -> CODE(B) 4.2 While Remote Start, press STRAT BTN, it will Turn Off The Remote Start 5.
PAGE 3
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.