User's Manual
9
1. Press and hold
and buttons at the same time until one long beep is heard.
Programming has now been entered.
2. Within 5 seconds press and hold
button until one beeping sound is heard.
3. To exit programming mode, take no action for five seconds. The remote control will
generate two long beeps to indicate programming mode has been exited.
2. Vibration / Melody Mode: It is useful when you are in a noisy place and difficult to hear beep sound
from the remote control as the remote control in this mode, vibrates it if your security system is triggered.
1. Press and hold
and buttons at the same time until one long beep is heard.
Programming has now been entered.
2. Within 5 seconds, press the
button to select the mode of vibration or melody, the
icon will displayed on the LCD screen to show the LCD remote transceiver is on
vibration mode.
3. To exit programming mode, take no action for five seconds. The remote control will
generate two long beeps to indicate programming mode has been exited.
3. Power Save Mode: While the power save mode, the LCD remote transceiver “sleep” until a button is
pushed, extending the life of battery. When power save mode is “Off”, the remote control will wake up
periodically to check for messages from the security module..
1. Press and hold
and buttons at the same time until one long beep is heard.
Programming has now been entered.
2. Within 5 seconds, press the
button to toggle “On” or “Off”. The remote will beep
once for “On”, twice for “Off”. When power save mode is “On”, the icon on
the LCD screens to indicate entry the “power save mode”
3. To exit programming mode, take no action for five seconds. The remote control will
generate two long beeps to indicate programming mode has been exited.
4. Screen Lamp ON: Press the button once, the LCD screen lamp will turns on for 5 seconds
5. System’s Status Check When you want to check the system’s present status
through the LCD screen, Press the transceiver
button first, within 3 seconds press
and buttons at the same time. It responds with one melody sound, the LCD
screen should be illuminated.
Note: If it has no responds then you are out of range.
6. Clear the Flash Icon and Melody Sound: Press the button first, within 3 seconds press and
buttons at the same time. It will clear the flash icon and melody sound on the LCD screen transceiver
7. Stop The Trigger Melody Sound: While triggering the alarm the LCD screen will alert user through
melody sound and flashing trigger icon, press any button on the LCD remote transmitter to stop melody
sound
only, the remote control buttons will not send a command to the system.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired
operation.
Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.