User's Manual

8
Remote Transmission
You are transmitting the signal to
control unit
In – Range Indicator
Your are within the remote control
range.
Trunk/Hood Trigger
Trunk or Hood is illegally opened
(Zone 2)
Door Open Warning
Doors are illegally opened (Zone 3)
Shock Sensor Trigger
Trigger on Shock Sensor (Zone 4)
Ignition Trigger
Trigger on Ignition Switch (Zone 5)
Warn Away trigger
Trigger on Shock Sensor (Zone 1)
Low Battery
You have to replace the battery of
remote control.
Engine Starting
Your vehicle engine starting by remote
control
Engine Running
Your vehicle's engine is running
Timer Control Start
Engine start every 2 / 3-hour.
Driver paging / Lose and Found
Someone is paging you in front of your
vehicle
Vibration Mode
Remote Control vibrates when the
system is triggered
Power Save Mode
Save the battery power
C. PROGRAM MODE FOT LCD REMOTE CONTROL TRANSCEIVER:
Transceiver Button System Function Remark
+ -
Switching code for 2nd / 1st Car
Operation
Press within 5 seconds
+ -
Melody / Vibration Mode Press within 5 seconds
+ -
Power Save Mode Press within 5 seconds
LCD screen lamp turns on for 5 seconds.
- +
System’s Status Check Press within 3 seconds
- +
Clear the Flash Icon and Melody Sound Press within 3 seconds
1. Second Vehicle Security Operation: Your remote transmitter can be utilized to control a second
vehicle security system. To program the remote control transmitter to a second vehicle, follow the
instructions for Transmitter programming. All programming parameters be the same except for the
following:
For Regular Remote Control Transmitter:
1. Prior to pushing any button on the transmitter. Press the Select II button first on the transmitter.
2. Once
II button is pressed the LED on the transmitter will illuminate for 3.5 seconds to indicate the
second transmitter pin code has built-in.
3. While the LED is illuminated, press any button on the remote control transmitter to control a second
vehicle security system.
For 2-way LCD Remote Control Transceiver:
2nd Car Operation: While the “II” icon display on the LCD screen, you can remote control and
communicate with a second vehicle security system. It has two short “bi” sounds while pressing the button
of the LCD screen transceiver.
1. Press and hold
and buttons at the same time until one long beep is heard.
Programming has now been entered.
2. Within 5 seconds press and hold
button until two beeping sounds is heard and
the “
II” icon will display on the LCD screen to indicate the second transceiver pin
code has built-in.
3. To exit programming mode, take no action for five seconds. The remote control will
generate two long beeps to indicate programming mode has been exited.
Back to 1st Car Operation: You can remote control and communicate with a first vehicle security system.
It has one short “bi” sound while pressing the button of the LCD screen transceiver.