User's Manual

MAY/03/2004
750R OP
13
F - (2-second)
Enable / Disable Bi Sound (Bi) While
Pressing Button
1. Screen Lamp ON: Press and hold the F button one second, with one melody sound and the LCD
screen lamp will turns on for 5 seconds
2. Power Save Mode: While the power save mode, the LCD remote transceiver uses “0”
current to save the battery power.
Entry: Press & hold the F button for 5 seconds, with one melody sound and icon
on the LCD screen to indicate entry the “power save mode”.
Exit: Press any button of the LCD remote transmitter to exit the “Power Save Mode”.
3. Clear the Flash Icon and Melody Sound: Press the F button 3 times within 3 seconds will clear the flash
icon and melody sound on the LCD screen transceiver
4. Stop The Trigger Melody Sound:
While triggering the alarm the LCD screen will alert user through
melody sound and flashing trigger icon, press any button on the LCD remote transmitter to stop melody
sound
only.
5. Button Lock: It is useful if you want to disable the transmission function of the remote
control temporarily to prevent from any inadvertent pressing of buttons by others. Press
the
F button first, within 3 seconds press and hold the ( ) button for 2 seconds to
activate or cancel the button lock function, the
icon will displayed on the LCD screen
to show the LCD remote transmitter is on “Button Lock”.
6. Vibration / Melody Mode:
It is useful when you are in a noisy place and difficult to hear beep sound from the
remote control as the remote control in this mode, vibrates itself if your security system is
triggered.
Press the
F button first, within 3 seconds press and hold the ( ) button for 2
seconds to select the mode of vibration or melody, the
icon will displayed on the
LCD screen to show the LCD remote transceiver is on vibration mode.
7. Enable / Disable Bi Sound While Pressing Button:
It has a short “bi” sound while pressing the button of the LCD screen transceiver
If you want mute the “bi” sound mute always while press button. Press the
F button first, within 3 seconds
press and hold the
(Bi) button for 2 seconds to disable the “bi” sound.
8. Low Battery Indication:
When the power of the battery weakens, it has two short “bi” sound and flash
icon while pressing
the button of the LCD screen transceiver.
9. Set Up Fixed Count Down Timer:
1. Press the
F button first, within 3 seconds press and hold the ( ) button for 2 seconds, the LCD
screen will shows
icon and timer (ie. 0:10) ,
2. Press the
( ) button again showing next order time on the screen (ie.0:20), press them again
(ie.0:30)…..and so on.
3. Leave the buttons starting count down then
icon flashes
Note: 1.The count down period is fixed as 10 minutes, 20 minutes, 30 minutes, 1 hour, 1.5 hours and 2
hours maximum.
2.When count down timer showing 0:00 means to turn off the timer.
3. Press
F button for real time indication when the timer is counting down.
10. Out Of Range Indication:
The system will automatically check the range every 20 minutes after armed.
1. If user is within the range, the
icon will display on the LCD screen.
2. If user is out of range, it has five short “bi” sounds and the
icon will disappear on the LCD screen.