User's Manual
Table Of Contents
- BLACK 4-PIN CONNECTOR. – TWO-WAY TRANSCEIVER/ANTE
- The Two-way transceiver/antenna mounts on the location above the belt line (dashboard) of the vehicle for best reception. We suggest you mount it on the lower left or upper left-hand side of windshield.
- - Remove the protective tape backing.
- - Carefully align the two-way transceiver/antenna and apply to windshield.
- METHOD 1
- METHOD 2
MAY/18/2005
Brown/Red
Wire: (
+
) Positive Safety Shut Down Input for Brake switch.
Thin Black
Wire: (
-
) Neutral Safety Switch Input &
(
-
) Remote Start Toggle Switch Input
Violet/White
Wire: Tach. Signal Input
Gray
Wire: (
-
) Negative Safety Shut Down Input for Hood pin switch
IMPORTANT NOTE:
Directly connect the Thin Black wire to the “GROUND” when this wire is not
used.
Black/White
Wire: (-) 200 mA Dome Light Control Output
Red/White
Wire: (-) 200 mA Channel 3 (Trunk) Output
Blue/Black
Wire: (-) 200 mA Ignition 3 Control
Ot t
LT Green/Black
Wire: (-) 200 mA Programmable output
Dual Pulse Door Unlock Output (Factory Default setting)
Or Factory Disarm Signal Output
Or Start Status (Shock Sensor Bypass Control) Output
Brown/Black
Wire: (-) 200 mA Programmable output
Factory Security Rearm Signal Output (Factory Default setting)
Or Ground Output During Start (Crank).
DELUXE 200-LCD
2