User's Manual

MAY/18/2005
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency.
1. Press and hold the
button for 3 second. The horn (if installed) will immediately sound.
2. During panic mode, the normal function of this transmitter button will be suspended.
3. To stop the alarm, press and hold
button on the transmitter again for 3 seconds.
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
DOME LIGHT CONVENIENCE DELAY & SUPERVISION
Upon disarming, the interior light will remain on for 30 seconds.
Note: Turn on the ignition switch or lock the vehicle’s door will turn off the dome light.
IGNITION CONTROL DOOR LOCK/UNLOCK..
If the vehicles door locks have been interfaced to the system, the system will automatically lock the
vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is
turned “OFF”.
TRUNK RELEASE (CHANNEL 3) OUTPUT.
Press and hold button on the transmitter for two seconds to remote control the trunk release or other
electric devices.
VIBRATION / MELODY MODE:
It is useful when you are in a noisy place and difficult to hear beep sound from the remote control as the
remote control in this mode, vibrates it if your security system is triggered.
1. Press
button first, within 5 seconds, press the button to select the mode
of vibration or melody, the
icon will displayed on the LCD screen to show the
LCD remote transceiver is on vibration mode.
2. To exit programming mode, take no action for five seconds. The remote control
will generate two long beeps to indicate programming mode has been exited.
SCREEN LAMP ON:
Press the button once; the LCD screen lamp will turns on for 5 seconds
REMOTE START OPERATION
TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press
button twice on the transmitter
2. The parking light will activate to indicate the remote start received the signal. (A
melody sounding from your Remote LCD transceiver and “
” icon will flashes on the
LCD screen to confirm the remote start was activated.)
3. The engine will start approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking light will turn on again
and climate controls will activate and adjust the vehicles interior temperature to your
preset setting. (While the vehicle is running, the “
” icon and the “minutes” digit on
the LCD screen will flash and it will indicate count down timer based on the 5, 10, 20
or 30 minute run time set up by your installation center.)
5. The vehicle will run for 5 to 30 minute cycle and automatically shut down. (When the
unit shuts off the count down timer will turn off and the transmitter will play a melody.)
Note: The Remote Start Unit will not start the vehicle if any one of the following
conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF position. (If installed)
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”
5. Pull down the hand brake. (for Standard Transmission Gear Vehicle)
Activate
Remote Start
Engine
Running
TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START:
To operate the vehicle while engine running on the remote start.
1. Insert the ignition key and turn it to “ON” (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.
TEMPORARY STOP FEATURE:
deluxe 200 OP 2