User's Manual

ManualsBrandsAdvance Security ManualsAutomotiveCar Alarm Transceiver

PROGRAMMABLE OPTIONS

You can program multiple options in one session if you start with the lowest option and continue

on to higher options [if needed] without repeating steps #1-3 below. For example, you can follow

the programming steps to change Option #2 to “OFF” by pressing the lock button on the remote,

then you can continue pressing the program button additional times to get to a high number option

and change the setting without having to repeat Steps 1-5. You can only go from low to higher

option numbers in one session.

To Engage Option Programming:

1. Open hood (ground the Blue wire if no hood pin switch is installed)

2. Turn Key to the ON position

3. Press program / valet button 5 times, after a few seconds the unit will flash the

lights 5 times.

4. Push the valet/program button [again] the number of times that corresponds to

the option number desired (1 thru 20). You must get a light flash after each

button press. See chart on next page for option list.

5. When you reach the desired programming level, Press button #1, #2, #3 or #4 to

change the option.

6. Turn Ignition OFF, Close hood and check for changed features. Change each

option individually repeating #1-5.

Summary of content (5 pages)

PAGE 1
PROGRAMMABLE OPTIONS You can program multiple options in one session if you start with the lowest option and continue on to higher options [if needed] without repeating steps #1-3 below. For example, you can follow the programming steps to change Option #2 to “OFF” by pressing the lock button on the remote, then you can continue pressing the program button additional times to get to a high number option and change the setting without having to repeat Steps 1-5.
PAGE 2
PROGRAMMABLE OPTION RESET This system provides a reset method to restore all options to FACTORY DEFAULT VALUES as listed in the “Button #2” column of the programmable option chart on pages 18-19. This can be helpful if you have lost track of the option settings on your system, or when you are moving the system from car to car and want a “clean slate”. 1. Open hood (ground the Blue Hood Switch Wire if no hood pin is installed) 2. Turn Key to the ON position 3.
PAGE 3
8 9 10 11 12 13 14 Siren Chirps with Arm/Disarm Override PIN Code Disarm on Trunk pop Open Door Warning Lock/Unlock Pulse Double Unlock Pulse Carjack Enable/Disable OFF *ON ON *OFF OFF *ON 5 seconds *60 seconds 3.5 Sec. *0.80 Sec.
PAGE 4
IGN OFF WAIT FOR 4 FLASHES (BLUE WIRE GROUNDED) PRESS 4X's 2-WAY SYSTEMS & "SideKick" REMOTES FLASH 2, 3, or 4 X's LOCK & UNLOCK PRESS TOGETHER IGN OFF COMPLETE
PAGE 5
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.