User's Manual

APR. 25, 2003
ALA761 IN
12
Channel 3 (4/ 5 / 6) Timer Control Output Programming
Enter:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 8 times and hold it until four chirps with a long chirp is hearing then release the
valet switch. You are now in the Alarm feature ‘IV’ programming mode.
Timer Program:
1-a. Press and release the transmitter
button 4 times, [4] LED flash, [4] siren/horn chirp to indicate
your are in features “Channel 3 Timer Programming mode”.
1-b. Press and release the transmitter
button 4 times, [4] LED flash, [4] siren/horn chirp to indicate
your are in features “Channel 4 Timer Programming mode”.
1-c. Press and release the transmitter
button 4 times, [4] LED flash, [4] siren/horn chirp to indicate
your are in features “Channel 5 Timer Programming mode”.
1-d. Press and release the transmitter button 4 times, [4] LED flash, [4] siren/horn chirp to indicate
your are in features “Channel 6 Timer Programming mode”.
2. Press and hold the valet switch, the timer will immediately start.
3. When the desired interval has passed, release the valet switch. 1 long chirp for confirmation.
(Set to any interval between 1 second and 2 minutes)
Note 1:
If your built-in timer controls window/sunroof closure in your car DO NOT change the timer setting! This
requires installer-only programming. Changing the value will adversely effect operation and may cause
damage.
Note 2:
Momentary output = The momentary output selection will output a negative signal from the Channel 3
(4/5/6) output immediately when the channel 3 (4/5/6) button is pressed and will continue until the button is
release.
Latched output = The latched output selection will output a negative signal as soon as the Channel 3 (4/5/6)
button is pressed and will continue until the button is pressed again.
Latched output / reset with ignition = The latched / reset with ignition output selection operates just like
the latched output but will reset or stop when the ignition is turned on.
ALARM FEATURE “V” PRORAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 10 times and hold it until five chirps with a long chirp is hearing then release the
valet
switch. You are now in the Alarm feature ‘V’ programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
Exit the programming mode. (3 long chirp & 3 parking light flashes to confirm this exit.)
2.
Override Without
Password Pin Code
Override With
Password Pin Code
3
“TEST” Mode for
Zone 2 / instant
trigger & Zone 3 /
Door trigger
“TEST” Mode for
Zone 1 & Zone 4 (2
Stage Shock
Sensor)
4
Panic with Ignition
off
Panic with Ignition
on & off
Panic with Ignition
on & off. Panic
with No time limit.
Without Panic
function.
Exit: Press the button on the transmitter. A 3 long chirps & 3 parking light flashes to confirm exit.
Password Pin Code Setup:
Enter:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 times and stay in OFF position.