User's Manual

OCT/11/2002
RST871A OP 14
Time Monitor Alert Alarm
You have set morning call alarm
Count Down Timer
Reminder when time is up for parking
Power Save Mode
Save the battery power
Vibration Mode
Remote Control vibrates when the
system is triggered
Button Lock
Disable the transmission function
temporarily
Driver paging
Someone is paging you in front of
your vehicle
Low Battery
You have to replace the battery of
remote control.
C. PROGRAMMING OF THE LCD REMOTE TRANSMITTER:
Transmitter Button Description Operation
(1 second)
LCD screen lamp turns on for
5 seconds.
Press and hold for 1 second
1 melody sound to confirm enters.
(3 seconds)
Timer Programming Mode. Press and hold for 3 seconds
2-melody sounds to confirm enter.
(5 seconds)
Power Save Mode Press and hold for 5 seconds
1 melody sound to confirm enters.
- -
Clear the Flash Icon and Melody Sound on
the LCD Screen Transmitter
Press within 3 seconds
- (2-second)
Button Lock ( ) enable / disable
Press within 3 seconds
- (2-second)
Melody / Vibration ( ) Mode
Press within 3 seconds
- (2-second)
Program Count Down Timer ( )
(10-Minute / 20M / 30 M /1Hour /1.5H /
2.0H)
Press within 3 seconds cycling
*leave the buttons starting count
down then flashes
- (2-second)
Enable / Disable Bi Sound (Bi) While
Pressing Button
1. Screen Lamp ON: Press and hold the button one second, with one melody sound and the LCD
screen lamp will turns on for 5 seconds
2. Power Save Mode: While the power save mode, the LCD remote transmitter uses “0” current to save the
battery power.
Entry: 1. Press & hold the button for 5 seconds, with one melody sound and
icon on the LCD screen to indicate entry the “power save mode”.
2. Under the “Active Arming Mode” and Disarm mode. Turn the ignition switch
to on, the LCD remote transmitter will automatically entry the “Power Save
Mode”
Exit: Press any button of the LCD remote transmitter to exit the “Power Save Mode”.
3. Clear the Flash Icon and Melody Sound: Press the button 3 times within 3 seconds will clear the
flash icon and melody sound on the LCD screen transmitter
4. Stop The Trigger Melody Sound: While triggering the alarm the LCD screen will alert user through
melody sound and flashing trigger icon, press any button on the LCD remote transmitter to stop melody
sound only.
5. Button Lock: It is useful if you want to disable the transmission function of the remote control temporarily
to prevent from any inadvertent pressing of buttons by others. Press the
button
first, within 3 seconds press and hold the ( ) button for 2 seconds to
activate or
cancel the button lock function, the
icon will displayed on the LCD screen to show
the LCD remote transmitter is on “Button Lock”.
6. Vibration / Melody Mode: