User's Manual

OCT.09, 2002
RST871A 20
2. Push the Valet switch 10 times and hold it until five chirps with a long chirp is hearing then release the valet
switch. You are now in the Start feature ‘ II’ programming mode.
Select “Checking Type”:
3. Press the transmitter and button at the same time to set the “Voltage Checking Type”. [2] LED flash,
[2] chirp to confirm this setting
4. Once you complete step 3, you can adjust and test “Start Timer” as below:
START TIMER PROGRAMMING: (TEST and ADJUST)
While the system stay in Start Feature “II” programming mode,
1. Press the button twice on the transmitter to start the vehicle.
2. If everything goes well:
Wait for 15 seconds:
a. If the engine still running.
I. Press the button twice on the transmitter to stop engine running. You have been completed this
programming successfully.
II. Press button on the transmitter to exit the program mode. There will be 3 long chirps & 3 parking
light flashes for confirmation.
b. If the engine shut down after the vehicle has been started.
I. Press the ' button twice on the transmitter to stop engine running.
II. Press button on the transmitter to set “Check Level” to LOW position. [2] LED flash,
[2] chirp to confirm this setting
III. Repeat the step1 – 2.
3. If the crank time is too long, (Engine already successfully running, while still cranks):
a. Press the button twice on the transmitter to stop engine running.
b. Press button on the transmitter to set proper “Start Timer”. The chirp & LED pause will confirm this
enter. (Decrease “Start Timer” is necessary.)
c. Repeat the step1 – 4.
4. If the crank time is too short, (Engine not running, while stops cranks):
a. Press the button twice on the transmitter to stop engine running.
b. Press button on the transmitter to set proper “Start Timer”. The chirp & LED pause wi ll confirm this
enter. (Increase “Start Timer ” is necessary.)
c. Repeat the step1 – 4.
Timer Checking Type
Enter Start Feature ‘ II’ Programming Mode:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 10 times and hold it until five chirps with a long chirp is hearing then release the valet
switch. You are now in the Start feature ‘ II’ programming mode.
Select “Checking Type”:
3. Press the transmitter and button at the same time to set the “Timer Checking Type”. [3] LED flash,
[3] chirp to confirm this setting
4. Once you complete step 3, you can adjust and test “Start Timer” as below:
START TIMER PROGRAMMING: (TEST and ADJUST)
While the system stay in Start Feature “II” programming mode,
1. Press the button twice on the transmitter to start the vehicle.
2. If everything goes well:
a.Press the ' button twice on the transmitter to stop engine running. You have been completed this
programming successfully.
b.Press button on the transmitter to exit the program mode. There will be 3 long chirps & 3 parking light
flashes for confirmation.
3. If the crank time is too long, (Engine already successfully running, while still cranks):
a.Press the button twice on the transmitter to stop engine running.
b.Press the button on the transmitter to set proper “Start Timer”. The chirp & LED pause will confirm this
enter. (Decrease “Start Timer” is necess ary.)
c.Repeat the step1 – 4.
4. If the crank time is too short, (Engine not running, while stops cranks):