User's Manual

OCT.09, 2002
RST871A 18
Exit: Press any button (except button) of the transmitter to exit the password pin set up mode. A 3 long
chirps & 3 parking light flashes to confirm exit.
REMOTE START FEATURE PROGRAM MODE.
START FEATURE “I” PRORAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 8 times and hold it until four chirps with a long chirp is hearing then release the valet
switch. You are now in the Start feature ‘ I’ programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
10 minutes run time 20 minutes run time 30 minutes run time 5 minutes run time
2
Factory alarm disarm
with channel 3 on
Without this feature
3
Constant parking
light output
Flashing parking
light output
4
Door lock before start Door lock after
shut-down
Door lock before
start and Door lock
after shut-down
Without this feature
5
+
Press
-
button =
Activate Remote
Start.
Press
+
button =
Activate Remote
Start.
Press button =
Activate Remote
Start.
6
+
H5/8 White / Blue
Wire =
1 pulse activate
H5/8 White / Blue
Wire =
2 pulse activate
H5/8 White / Blue
Wire =
3 pulse activate
7
+
Temperature-Control
Starting OFF
Temperature-Control
Starting 5 F
Temperature-Control
Starting – 4 F
Temperature-Control
Starting – 22 F
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. A 3 long chirps & 3 parking light flashes to
confirm exit.
SAFE START (Child safety mode)
Factory defaults setting to press the button twice to start the vehicle.
Programming this feature to eliminate an accidental remote start, when kids enter this transmitter, it requires:
The user press the transmitter and buttons at the same time to start the vehicle.
START FEATURE “II” PRORAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 10 times and hold it until five chirps with a long chirp is hearing then release the valet
switch. You are now in the Start feature ‘ II’ programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
Exit the programming mode. (3 long chirp & 3 parking light flashes to confirm this exit.)
2
+
Tachometer
checking type.
Voltage checking
type
Timer checking type