PROPLM Owner's Manual Remote Vehicle Security and Keyless Entry System IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information.
Table of Contents Features and Benefits ............................................................... 3 Using Your Remote Control ....................................................... 4 Arming the system Pre-arm mode Disarming the system Two stage unlock Confirmation chirps Car Finder Personal protection alarm Trunk release Using Your Remote Control, Continued ................................... 5 Using valet mode Automatic Convenience Options .............................................
Features and Benefits Two Easy-to-Use Weather-Resistant Remote Controls The remote controls included the PROPLM Security System utilize durable, moisture resistant cases and sealed rubber buttons for reliability and long life. Rolling code technology prevents the transmitter signals from being duplicated. The button functions are clearly labeled to make the system easy to operate.
Using Your Remote Control Arming the Security System To arm the system, exit the vehicle, close all doors, then press the LOCK button on the remote control. The system will flash the parking lights 2 times, indicating the system is armed, has locked the doors (if equipped and connected) and activated the starter disable feature. The status indicator (LED warning light) will blink steadily, once per second.
Using Your Remote Control, continued Using Valet Mode To engage valet mode: 1. Turn the ignition key ON/OFF, ON/OFF, ON/OFF. 2. The LED will flash 2 times quickly then pause indicating that the system is in valet mode. When valet mode is activated all security functions will be disabled. To disengage valet mode: 1. Turn the ignition key ON/OFF, ON/OFF, ON/OFF. 2. The LED will turn off indicating that the system has exited valet mode.
When Your Security System is Triggered, Continued Attempted Intrusion Identification Pressing UNLOCK after a full 30 second trigger cycle has completed, the horn will honk 4 times and the LED will flash a number of times to indicate which input triggered the alarm. Turning on the ignition or pressing the valet/override button will reset the LED flashes, pressing the valet/override button will also honk the horn to match the LED flashes before it resets.
System Maintenance, Continued Adding Remote Controls to Your System The PROPLM Security System has the ability to operate from up to 4 remote controls. Follow these steps to add a remote control to your system. 1. Make sure the system is disarmed and the ignition is off. 2. Turn the ignition on. 3. Press and hold the override button. After 10 seconds the system will chirp 3 times indicating the system has entered programming mode. 4. Release the button. 5.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
