User's Manual

7
Programmable Features (Available to 6908(A), 6918(A), 6928(A), 7919P and 7921P Security
Systems)
(Contact your car dealer for adjustment of these features)
Ignition Key Controlled Door Lock/ Unlock: (Remote door lock/unlock option must be installed)
With this feature activated, the door lock system of the vehicle will become locked 3 seconds after the ignition
key is turned to the on position (All doors). When the ignition key is turned to the off position, the door locks
will immediately become unlocked (All doors).
Note: If the “unlock drivers door first” option has been installed, only the drivers door will become unlocked
when the ignition key is turned off.
Chirp Status Indicator Delete:
De-activating the chirp indication system will eliminate the arm and disarm chirp indicators. For your safety,
the tamper warning chirp indicator will always be active.
Automatic Arming of Security System:
When the automatic arming of security system feature is programmed on, the security system will
automatically become armed 30 seconds after the last protected entrance is closed without requiring a signal
from the remote transmitter. (Ignition switch must be off)
Automatic Door Locking: (Remote door lock/unlock option must be installed)
If it is desired to have the vehicle’s power door locking system become locked at the same time the security
system becomes armed by the automatic arming of security system feature, the automatic door locking
programming should be on.
Upgrade Options Available From Your Car Dealer (At an Additional Cost) (Continued)
Option #5: Unlock Driver’s Door First (Requires option #1 to be installed and applies to 6908 (A) , 6918 (A) ,
6928 (A) and 7921P only)
Installing option #5 will allow your Silencer
®
security system to unlock only the driver’s door upon disarming
the security system. To unlock the remaining doors, press the ARM button once again within 3 seconds of
disarming the security system.
Option #6: Dual Zone Shock Sensor (Applies to 6908
(A) , 6918 (A) , 6928 (A), 7919P, and 7921P Only)
Installing option #6 will increase the level of security provided by your Silencer security system. Zone #1 of
the dual zone shock sensor will detect lighter non-threatening disturbances that would normally set off most
sensors and trigger the security system. If zone #1 is activated the security system will emit a single chirp
from the horn/siren. This single chirp is a pre-warning if a would be thief is attempting to enter your vehicle.
Zone #2 detects heavier impacts that are considered threatening and immediately triggers your security
system by sounding the horn/siren and flashing the parking lights.
7955UM 2/21/05 4:22 PM Page 7