User's Manual

5
Remote Panic
(Applies to 6908(A), 6918(A), 6928(A), 7919P, 7921P only, but is an option on 6904(A))
Press and hold the button for more than 3 seconds and the security system will respond in the
following manner:
A. The horn/siren will begin sounding.
B. The parking lights will begin flashing. (Applies to 6908(A), 6918(A), 6928(A), 7919P and 7921P only,
but is an option on 6904(A))
To turn off the panic alarm, press and release the button on the transmitter. The horn/siren will stop
sounding and the parking lights will stop flashing.
Note 1: If you do not turn off the panic feature with the transmitter, the panic alarm will sound for 60
seconds and then turn off by itself.
.
Note 2: (6904(A) Only) For remote panic to operate an optional status indicator must have been installed.
.
Note 3: (6904(A) Only) For flashing lights to operate an additional module must have been installed.
Note 4: (6915K3 Only) The panic button on this transmitter is the button and uses the same procedure
for operation as the button on the other transmitters.
User Discretion Silent Arming (Applies to 6908(A), 6918(A), 6928(A), 7919P and 7921P Only)
Your Silencer
®
security system can be instructed to become armed or disarmed without the horn/siren chirps by
the remote transmitter. To operate this feature at any time, simply press the ARM button and the DISARM button
at the same time. The combination of the two signals will instruct the security system to arm or disarm silently.
60 Second Re-Arming: (Applies to 6908(A), 6918(A), 6928(A) , 7919P and 7921P Only)
If your Silencer
®
security system has become triggered, the horn/siren will sound for 60 seconds and then stop
and re-set to a fully armed condition.
Note: If a protected entrance is left open, your Silencer
®
security system will remain triggered for two more 60
second cycles then fully re-arm excluding the door input trigger. (Door input trigger is no longer functional)
Closing the entrance will re-set the door input trigger within 7 seconds.
Removable Valet/Override Switch Operation (continued)
How to Get Back to Security System Activation Mode:
1. Place the ignition key switch to the “on” position.
2. Place the valet switch to the “off” position.
3. Place the ignition key switch back to the “off” position. You will notice that the LED indicator will be
off. This indicates that you have exited the valet mode and your Silencer
®
will operate normally.
4. Remove the valet switch.
Secondary RF Protection Mode
Every time you disarm your Silencer
®
security system with your transmitter, the security system will start an RF
protection mode countdown. This is a timed secondary protection mode to insure that the radio signal used to
disarm the security system was from your transmitter. After the system is disarmed by radio signal, it will
count down for 60 seconds and then become re-armed if no one enters the vehicle.
Note 1: This feature is automatic and not deletable on the 6904 (A) model security system.
Note 2: The feature is only active when 6908 (A) , 6918 (A), 6928 (A), 7919P or 7921P has been programmed
to automatically arm.
7955UM 2/21/05 4:22 PM Page 5