User's Manual

Emergency Override (continued)
When this Silencer model is armed, the engine will not crank over. This is how to identify a 4900 system. If
you have this type of system, perform the following procedure to activate the override function:
1. Turn the ignition key all the way to the “START” position and hold it there for 10 seconds then turn it off.
2. Wait for 10 seconds.
3. Turn the ignition key back to the “START” position and hold it there for 10 seconds then turn it off.
4. Wait for 10 seconds.
5. Turn on the ignition key to the “START” position and the engine will start.
Model 4900
3
When this Silencer model is armed, the engine will crank over but it will not run normally. This is how to identify
a 4901 system. If you have this type of system, perform the following procedure to activate the override function:
CAUTION: If you have a 4901 system installed, cranking the engine for more than 5 seconds may cause
the “Check Engine” light to illuminate on some vehicles. If this should occur, the vehicle battery must be
disconnected for 30 seconds and then re-connected to turn off the “Check Engine” light.
1. Turn the ignition key to the “ON” position for 10 seconds then turn it off.
2. Wait for 10 seconds.
3. Turn the ignition key back to the “ON” position for 10 seconds then turn it off.
4. Wait for 10 seconds.
5. Turn on the ignition key to the “START” position and the engine will start.
Note 1: For vehicles with manual transmission, you must depress the clutch while performing the Emergency
Override procedure.
Note 2: You must perform the Emergency Override procedure EACH TIME THE CAR IS STARTED until your
transmitter is replaced or repaired.
Model 4901
The valet mode allows you to temporarily turn off the passive arming function, eliminating the need to give
your transmitter to a parking attendant or garage mechanic.
To enter the valet mode, perform this procedure:
1. Press the disarm button on your transmitter to insure the device is disarmed (you will hear 2 beeps
from the device).
2. Within 3 seconds of pressing the disarm button, press and release the “Valet On” button 3 times slowly.
The device will emit 3 long beeps to indicate the valet mode “On” condition.
To exit the valet mode, follow this procedure:
1. Press the “Disarm” button on your transmitter (you will not hear any beeps).
2. Within 3 seconds of pressing the disarm button, press and release the “Valet Off” button 3 times slow-
ly. The device will emit 1 long beep to indicate the valet mode is “Off”.
Valet Mode
3-Button Transmitter
To enter the valet mode, follow this procedure:
1. Press the button on your transmitter to insure the device is disarmed (you will hear 2 beeps from the device).
2. Within 3 seconds of pressing the button, turn ignition On / Off 3 times and wait about 3 seconds, the
device will emit 3 long beeps to indicate the valet mode “On” condition.
To exit the valet mode turn ignition On / Off 3 times and wait about 3 seconds, the device will emit 1 long
beep to indicate the valet mode is “Off”.
1-Button Transmitter (Includes Passive Disarm Transmitter)
Emergency Override
There may come a time when it will be necessary to manually disarm your Silencer system without using
your transmitter. This condition occurs if the battery in your transmitter is low, dead or if your transmitter
becomes damaged or lost. In these circumstances, it will be necessary to use your ignition key to perform
an emergency override procedure to get your vehicle operational. Identify your Silencer model type and
repeat the procedure to perform the override function.
4900UMRevD 7/30/04 4:58 PM Page 3