User's Manual

3 GREEN/WHITE FACTORY ARM /

PULSE AFTER SHUTDOWN ( - )

This wire will supply a ( - ) 500mA pulse both upon arming the system and after

the remote start shuts down. This is typically used to re-lock the vehicle’s doors if

they unlock upon remote start shutdown. It can also be used to pulse a door pin-

switch wire to prevent the vehicle’s accessories from remaining on after remote

start shutdown.

6 PINK IGNITION 1 ( + )

Locate the vehicle’s ignition wire at the ignition switch.

Verification: This wire registers voltage when the key is turned to the ON (or

RUN) position. The voltage does not drop out when the key is turned to the

START (or CRANK) position.

Connect the PINK wire to the vehicle’s Ignition wire.

This wire is also used for Ignition 1 Output.

4 Pin Auxiliary Output Harness

1 LT GREEN/BLACK FACTORY DISARM /

PULSE BEFORE START ( - )

This wire will supply a ( - ) 500mA pulse both upon disarming the system and when

the remote start feature is activated. Locate the factory perimeter alarm disarm

wire from the key cylinder inside the drivers door.

Verification: This wire registers ground if the key is turned to the unlock

position in the driver’s door cylinder.

Connect the LIGHT GREEN/BLACK wire to the factory alarm disarm wire.

2 LT BLUE PULSE AFTER START ( - )

This wire will supply a ( - ) 500mA pulse upon successful completion of the remote

start activation sequence and is typically used to re-lock the vehicle’s doors upon

remote start if necessary.